Results 71 to 80 of about 132,171 (261)
A non-linear elastic-plastic stress analysis in a ductile double-lap joint
Science and Engineering of Composite Materials, 2013 In this study, an elastic-plastic stress analysis was proposed in order to obtain shear stress distribution in a double-lap joint, analytically. The solution was carried out using incremental theory.
Sayman Onur +4 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Thermomechanical fatigue tests of laser beam powder bed fusion (PBF‐LB) Inconel 718 show that the additively manufactured material reaches almost the lifetimes of conventionally‐rolled material under no‐dwell conditions. Introducing dwell times at the maximum temperature markedly reduces the lifetimes due to pronounced grain boundary sliding associated
Stefan Guth +6 more
wiley +1 more source
Investigation of natural frequencies of axially loaded thin-walled columns
MATEC Web of Conferences, 2018 The paper deals with correlation between natural frequencies of two steel thin-walled columns and the corresponding applied load. The structures are made of cold-formed lipped channel sections.
Żmuda-Trzebiatowski Łukasz
doaj +1 more source
Advanced Engineering Materials, EarlyView.This article presents the design, modeling, and characterization of air‐pressure–actuated programmable vibroacoustic metamaterials (PVAMM). The study focuses on leveraging air pressure to dynamically tune resonance frequencies for effective noise attenuation.
William Kaal +2 more
wiley +1 more source
ANALYSIS OF NON-LINEAR ELASTIC MATERIAL PROPERTIES OF PVC-COATED PANAMA FABRIC
TASK Quarterly, 2005 The aim of the present paper is to propose a method of laboratory tests to determine non-linear elastic properties of coated Panama fabric. The material parameters are specified on the basis of uniaxial tensile tests in the warp and weft directions ...
ANDRZEJ AMBROZIAK
doaj
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Non-Linear Analysis of Beams on Elastic Foundation by Finite Element Method
Journal of Engineering and Sustainable Development, 2006 This study is concerned with the behavior of beams on elastic foundation using finite element methods. The nonlinear behavior for reinforced concrete was taken into account addition to the nonlinear contact behavior of elastic foundation.
Mithaq A. Louis
doaj
Advanced Engineering Materials, EarlyView.Fungal mycelia grown into biodegradable scaffolds and infused with titania nanoparticles show enhanced ultraviolet shielding, thermal protection, and surface nonwettability. Properties were tuned by drying methods, revealing structure–function relationships.
Juwon S. Afolayan +2 more
wiley +1 more source
Influence of an Oxygen‐Free Atmosphere on Diamond‐Single‐Grain Scratching of Ti–6Al–4V
Advanced Engineering Materials, EarlyView.Single‐grain scratching of Ti–6Al–4V is investigated under controlled, oxygen‐free, and ambient atmospheres using a novel experimental setup with in situ high‐speed imaging. The approach enables direct observation of chip formation and adhesion under suppressed oxidation.
Berend Denkena +2 more
wiley +1 more source
Strength analysis of sandwich beams with linear elastic inner layer
Journal of Applied Mathematics and Computational Mechanics, 2022 Koichi Kimura
doaj +1 more source