Results 51 to 60 of about 417 (113)
Computer simulation of load-bearing elements and junction units in the calculation scheme of multistory frame buildings [PDF]
, 2023 In the last three decades, preference was given to the construction of monolithic buildings, but the construction of multistory frame buildings from prefabricated concrete is very relevant at the present stage.
Malakhova Anna
core +1 more source
The method of local impact for the analysis of structures for progressive collapse
MATEC Web of Conferences, 2018 A method for calculation on the progressive collapse, in accordance with which the account of the fall of ceiling panels on the underlying floor when the loss of bearing capacity of vertical frame elements in the form of local impact determined by ...
Saiyan Sergey, Paushkin Alexander
doaj +1 more source
Determination of destructive forces in a rod-cable arch
Structural Mechanics of Engineering Constructions and Buildings, 2019 The aim of research - comparison the results of the experimental data with the computer modeling the work of the strengthened brick-cable arch. Methods. Experimental and theoretical methods of research. Results.
Igor K. Dmitriev
doaj +1 more source
Методичні вказівки до виконання лабораторних робіт з курсу «Програмне забезпечення інженерних розрахунків» для студентів спеціальності 192 «Будівництво та цивільна інженерія» [PDF]
, 2022 Recommended for publishing by the scientific and methodical council of the Faculty of Engineering of Machines, Structures and Technologies of the TNTU. Minutes No. 3 from October «21», 2022.Introduction ... 5 Laboratory work № 1.
Sorochak, Andriy +1 more
core
ДО ПИТАННЯ РОЗРОБЛЕННЯ МЕТОДИК ТА АЛГОРИТМІВ СТРУКТУРНО-ПАРАМЕТРИЧНОГО МОДЕЛЮВАННЯ БУДІВЕЛЬНИХ ОБ’ЄКТІВ [PDF]
, 2020 At present, computer information technologies are widely used in architectural and construction design processes, which are implemented using CAD/CAM/CAE (Computer Aided Design / Computer Aided Manufacturing / Computer Aided Engineering) systems, such as
Регіда, Олег Віталійович
core +1 more source
International Journal for Computational Civil and Structural Engineering, 2019 An algorithm for calculating the geometric characteristics of steel I-beams with plate corrugated webs of arbitrary type is proposed. The algorithm is implemented using the I-beam with plate trapezoid webs as an example. The determination of reduced area
Tatiana Dmitrieva, Khukhuudei Ulambaya
doaj +1 more source
Use of monitoring system in Ekaterinburg [PDF]
, 2019 The monitoring of buildings and structures condition, as well as the timely implementation of corrective actions aimed at the elimination of adverse factors, are the most important aspects that shall be addressed at the construction stage.
Alekhin, V., Avdonina, L., Shipulin, E.
core +1 more source
NONLINEAR DYNAMIC ANALYSIS OF REINFORCED CONCRETE LARGE-PANEL BUILDING
International Journal for Computational Civil and Structural EngineeringA nonlinear dynamic analysis of large-panel reinforced concrete building (LPB) using LIRA-SAPR software is presented. LPBs, which became prevalent in the mid-20th century, have generally demonstrated good seismic performance during past earthquakes ...
Zaurbek Abaev, Azamat Valiev
doaj +1 more source
MATEC Web of Conferences, 2016 The paper presents an example of calculations of an assembled reinforced concrete hollow core slab of off-shuttering formation which has been reinforced with pre-stressed wire in its top and bottom areas. The numerical modelling of statically determinate
Panfilov Denis +2 more
doaj +1 more source
Dynamic Comfort Considerations in the Design of High-rise Buildings [PDF]
The following paper provides research analysis on the influence of wind on a building, considering the regional and local climate conditions, to improve dynamic stability and reduce wind disruption effects on high-rise reinforced concrete buildings.
Beka Matithaishvili +2 more
core +1 more source