Results 21 to 30 of about 15,522 (156)
Effects of Surfactants on Absorption of Water Vapor into Aqueous LiBr Solution
Zhileng xuebao, 2005 The purpose of this study is to prepare some basic experimental data for mechanism study of Marangoni effect and to look for some more effective additives to substitute 2-ethyl-1-hexanol or 1-octanol which are widely used in lithium bromide absorption ...
高洪涛, 原英治
doaj +2 more sources
Holodilʹnaâ Tehnika i Tehnologiâ, 2019 The efficiency of deep cooling air at the inlet of gas turbine unite to the temperature of 10 °С by waste heat recovery combined absorption-ejector chiller was analyzed in climatic conditions at Kharkov site, Ukraine, and Beijing site, China, and ...
A. M. Radchenko +2 more
doaj +1 more source
Известия высших учебных заведений: Проблемы энергетики, 2018 In this article the question of increase of efficiency of the combined cycle plant with single-loop heat-recovery boiler due to the inclusion in the scheme of absorption bromide lithium converter of heat.
R. N. Valiev +3 more
doaj +1 more source
International Journal of Electrochemical Science, 2009 Electrochemical noise results obtained for mild steel corrosion conditions under a lithium bromide-ethylene glycol solution and in the presence of different concentrations of lithium chromates (Li2CrO4) as corrosion inhibitor are shown.
E. Sarmiento +4 more
doaj +1 more source
Space cooling using geothermal single‐effect water/lithium bromide absorption chiller
Energy Science & Engineering, 2021 This research is proposed to fully investigate the performance of a single‐effect water/lithium bromide absorption chiller driven by geothermal energy. Since absorption cycles are considered as low‐grade energy cycles, this innovative idea of rejecting ...
Mamdouh El Haj Assad +6 more
doaj +1 more source
Hybrid Two-stage and Double-effect Lithium Bromide Refrigeration-heat Pump Compound Cycle
Zhileng xuebao, 2012 In CCHP system, The waste heat quantity emitted from lithium bromide absorption refrigeration is large and low grade, so it is difficult to use directly.
Huang Shaojun +3 more
doaj
Preparation and Characterization of Lithium Zirconium Silicate for CO2 Capture
Bulletin of Chemical Reaction Engineering & Catalysis, 2014 The samples of lithium zirconium silicate were prepared by precipitation, template and sol-gel meth-ods. The samples were prepared with several mol ratios of Li:Zr:Si.
T. S. Bhosale, A. G. Gaikwad
doaj +1 more source
International Journal of Electrochemical Science, 2012 Refrigeration absorption machines are again considered as suitable refrigeration systems and they are replacing compression machines due to the ban of chlorofluorocarbons (CFCs) and the strict regulations of hydrochlorofluorocarbons.
R. Leiva-García +3 more
doaj +1 more source
Surface tension of LiBr Aqueous Solution with Heat/mass Transfer Enhancement Additives
Zhileng xuebao, 2004 Surface tension of 62 wt% lithium bromide solution without and with several six-carbon, seven-carbon and eight carbon alcohol additives such as 4-methyl-2-pentanol, 2-ethyl-1-butanol, 1-hexanol, 2,4-dimethyl-3-pentanol, 4-heptanol, 2-heptanol, 1-heptanol,
高洪涛, 飛原英治
doaj +2 more sources
Lithium Bromide-Induced Structural Changes in a Nickel Bis-Alkoxide Complex
Acta Chimica Slovenica, 2013 The bis-alkoxide [(DEAMP)2Ni] (1, DEAMP = 1-(diethylamino)-2-methylpropan-2-olate) was found to react with trace amounts of lithium bromide to afford the bis-LiBr adduct 2, in which the oxygens of the DEAMP ligand coordinate to lithium to form a chiral ...
Hiromi Ichioka, David A. Vicic
doaj