Results 11 to 20 of about 1,221,101 (305)
Journal of Marine Science and Engineering, 2023 A complete subsea production system (SPS) is assembled by interconnecting subsea manufacturing facilities through subsea connectors. To ensure the reliability and longevity of the SPS, it is imperative to thoroughly investigate the mechanical behavior ...
Xiaoquan Hao +6 more
doaj +1 more source
Load transfer across the pelvic bone [PDF]
Journal of Biomechanics, 1995 Earlier experimental and finite element studies notwithstanding, the load transfer and stress distribution in the pelvic bone and the acetabulum in normal conditions are not well understood. This hampers the development of orthopaedic reconstruction methods. The present study deals with more precise finite element analyses of the pelvic bone, which are
Dalstra, M., Huiskes, R.
openaire +6 more sources
Hybrid (bolted/bonded) joints applied to aeronautic parts : analytical one-dimensional models of a single-lap joint [PDF]
, 2006 The load transfer in hybrid (bolted/bonded) single-lap joint is complex due to the association of two different transfer modes (discrete and continuous) through elements with different stiffness.
Huet, Jacques +2 more
core +2 more sources
World Electric Vehicle Journal, 2021 Load transfer is an important way of restoring a power supply after equipment failure or maintenance. However, current methods ignore cooperation between networks and users, and they also fail to take into account the vehicle-to-grid (V2G) potential of ...
Dongyu Mao +5 more
doaj +1 more source
Strengthening Mechanisms in Carbon Nanotubes Reinforced Metal Matrix Composites: A Review
Metals, 2021 Carbon nanotubes (CNTs)-reinforced metal matrix composites are very attractive advanced nanocomposites due to their potential unusual combination of excellent properties. These nanocomposites can be produced by several techniques, the most reported being
Íris Carneiro, Sónia Simões
doaj +1 more source
A three-dimensional finite element model of maximal grip loading in the human wrist [PDF]
, 2009 The aim of this work was to create an anatomically accurate three-dimensional finite element model of the wrist, applying subject-specific loading and quantifying the internal load transfer through the joint during maximal grip.
Bransby-Zachary, M. +7 more
core +1 more source
The Effect of Adding Nickel Element on Mechanical and Wear Properties of SiCp-Cu Composites [PDF]
Engineering and Technology Journal, 2010 Reinforced composites are prepared from a Copper as a matrix with SiCpowder in different percentage ( i.e 5-25 vol.%) .For each prepared reinforcedcomposite with respect to SiC addition , they divided into two parts , one undergo toaddition of Ni in ...
Samir B. Younis
doaj +1 more source
Applied Sciences, 2023 In order to explore the fracture law and structural evolution characteristics of overlying strata in deep high-stress mining, according to the geometric characteristics and mechanical causes of overlying strata in different mining stages of the stope ...
Xinfeng Wang +5 more
doaj +1 more source
Materials Research Letters, 2023 Interface characteristics are of great importance in mechanical performance for multi-phases heat-resistant Al alloys. Herein, Al3Sc precipitates were created at both Al/Al9FeNi interface and Al matrix inside Al–Fe-Ni eutectic alloy by microalloyed Sc ...
Zeyu Bian +7 more
doaj +1 more source
Behavior of a Large Diameter Bored Pile in Drained and Undrained Conditions: Comparative Analysis
Geosciences, 2020 Despite the difficulties in obtaining the ultimate capacity of the large diameter bored piles (LDBP) using the in situ loading test, this method is the most recommended by several codes and design standards.
Mohamed Ezzat Al-Atroush +3 more
doaj +1 more source