Results 81 to 90 of about 49,025 (266)

Oxygen‐Tunnel Indium Tin Oxide Vertical Channel Transistors with Enhanced Current Density and Reliability for Monolithic 3D Compute‐In‐Memory Systems

open access: yesAdvanced Functional Materials, EarlyView.
Oxygen‐tunnel (OT) indium tin oxide (ITO) vertical channel transistors (VCTs) enable reliable, high‐density gain‐cell memory for monolithic 3D integration. A sandwiched SiN/SiO2/SiN OT stack selectively regulates oxygen transport, suppressing parasitic electrode oxidation while stabilizing channel oxygen vacancies, thereby suppressing carrier injection
Hyeonho Gu   +17 more
wiley   +1 more source

Omnipolar Magnetic Field Detection by Superlattice‐Based Hall Sensor

open access: yesAdvanced Functional Materials, EarlyView.
Magnetic‐field‐induced electronic switching is demonstrated in unit‐cell‐engineered La0.7Sr0.3MnO3–BiFeO3 superlattices. Distinct substrate terminations modify magnetic and transport properties. Hall resistance measurements show omnipolar, hysteretic anomalous Hall switching above the Curie temperature, arising from Fe─Mn interfacial exchange, enabling
Mark Huijben   +6 more
wiley   +1 more source

Electrode and Microstructure Dependence of Oxygen Diffusion in Ferroelectric Hafnium Zirconium Oxide Thin Films

open access: yesAdvanced Functional Materials, EarlyView.
Significant nanoscale oxygen diffusion coefficient variations are measured in ferroelectric hafnium zirconium oxide films with grain boundaries and electrode interfaces exhibiting values 104 times larger than the grain cores. Overall coefficients are 10X larger for films prepared with metal nitride electrodes compared to refractory metals. New insights
Liron Shvilberg   +6 more
wiley   +1 more source

Historical Foundation and Practical Guideline for Ferroelectric Switching Kinetic Studies

open access: yesAdvanced Functional Materials, EarlyView.
The P and U pulses in the conventional PUND measurements are not identical because of the interplay between switching current and the measurement circuit components. This circuit effect can lead to a shift in polarization transients and misinterpreted physics in the switching kinetics.
Yi Liang, Pat Kezer, John T. Heron
wiley   +1 more source

Embedded Ferroelectric Nanoclusters Can Drive Polarization Reversal in a Non‐Ferroelectric Polar Film via the Proximity Effect

open access: yesAdvanced Functional Materials, EarlyView.
Ferroelectric nanoclusters create local internal fields in a normally non‐switchable polar film because of polarization mismatch at their interfaces. That field opposes polarization in the regions with larger polarization and reinforces polarization in the regions with smaller polarization.
Anna N. Morozovska   +5 more
wiley   +1 more source

Gate‐Programmable Linearization of Atomically Thin Nanoelectromechanical Resonators via Duffing Nonlinearity Cancellation

open access: yesAdvanced Functional Materials, EarlyView.
Gate bias is used to cancel Duffing nonlinearity in atomically thin MoS2 drumhead resonators, switching their response from hardening to softening and creating a nearly linear operating point. This electrical control suppresses hysteresis, enables stronger linear drive, and improves signal‐to‐noise ratio, offering a practical route to stable 2D NEMS ...
Pengcheng Zhang   +3 more
wiley   +1 more source

Monolithic Oxidation Enables Ultrathin Vertically Graded Tantalum Oxide for Low‐Voltage, Low‐Variability Memristive Switching

open access: yesAdvanced Functional Materials, EarlyView.
Monolithic UV‐ozone oxidation of Ta forms an ultrathin Ta2O5/TaOx bilayer enabling resistive switching with a vertical defect gradient. A stoichiometric surface layer over an oxygen‐deficient sublayer promotes localized filament nucleation near the top interface, enabling low‐voltage operation, and reduced cycle‐to‐cycle variability.
Seunghoon Yang   +11 more
wiley   +1 more source

Ambient‐Stable Transparent P‐Type CuI Transistors Via Room‐Temperature Pulsed Laser Deposition

open access: yesAdvanced Functional Materials, EarlyView.
An in situ PLD fabricated AlOx${\rm AlO}_x$/CuI/AlOx${\rm AlO}_x$ sandwich structure enables stable CuI TFTs with a field‐effect mobility of 2.3 ±$\pm$ 0.7 cm2${\rm cm}^{2}$ V−1${\rm V}^{-1}$ s−1${\rm s}^{-1}$ and excellent ambient stability. Complementary inverters based on CuI:Rb and ZnO:Al exhibit rail‐to‐rail voltage transfer characteristics and an
Yang Chen   +5 more
wiley   +1 more source

Semiconducting Polymers Post‐Functionalized With Ureido‐Pyrimidinone for Robust Stretchable Transistors

open access: yesAdvanced Functional Materials, EarlyView.
The design of intrinsically robust stretchable semiconducting polymers was achieved through OTBS‐mediated post‐functionalization of PDPP2T side chains with UPy units, generating dual hydrogen‐bonding motifs comprising weaker urethane linkages and strong quadruple UPy interactions along the long alkyl side chain, which is crucial for achieving desirable
Dinda Bazliah   +7 more
wiley   +1 more source

Polarization‐Dependent Synaptic‐Like Electro‐Optical Response in Ferroelectric Nematic Liquid Crystals

open access: yesAdvanced Functional Materials, EarlyView.
Ferroelectric nematic liquid crystals (FNLCs) offer fast, tunable polarization and low‐voltage operation but suffer from poor polarization retention at zero field. Semiconductor‐modified FNLCs enhance polarization retention and exhibit short‐ and long‐term electro‐optical responses, while also supporting spike‐type signal integrations.
Kutay Sagdic, Weiming Yao, Danqing Liu
wiley   +1 more source

Home - About - Disclaimer - Privacy