Results 11 to 20 of about 10,979,660 (212)

DEVELOPMENT OF LOW NOISE AMPLIFIER (LNA) FOR 5G WI-FI APPLICATIONS

open access: yes, 2023
This paper presents a wideband low noise amplifier (LNA) implemented in 0.15μm InGaAs pHEMT technology low-noise 5.15GHz-5.925GHz frequency range LNA (low noise amplifier) for 5G Wi-Fi applications. The proposed circuit is fabricated using 0.15μm InGaAs pHEMT technology, and it is powered by 3.5V supply.
Airpoint Co, Murod Kurbanov
openaire   +2 more sources

Narrowband Radio Frequency CMOS Low-Noise Amplifier (LNA) Design

open access: yes, 2022
The aim of this coursework is to design a radio frequency CMOS low noise amplifier (LNA) for the center frequency 2.2 GHz. The amplifier should have the minimum noise figure matching and impedance matching both at the input and the ...
Assim, Ara Abdulsatar
openaire   +2 more sources

A sub‐6GHz wideband low noise amplifier with high gain and low noise figure in 110‐nm SOI CMOS

open access: yesElectronics Letters, 2023
This letter presents a sub‐6 GHz wideband low noise amplifier (LNA) based on a double L‐type load network and utilizes the negative feedback technique.
Xiaowei Wang, Zhiqun Li, Tong Xu
doaj   +1 more source

Analytical Performance of Low Noise Amplifier Using Single-Stage Configuration for ADS-B Receiver

open access: yesJurnal Elektronika dan Telekomunikasi, 2021
Automatic dependent surveillance-broadcast (ADS-B) is an equipment of a radar system to reach difficult areas. For radar applications, an ADS-B requires a low noise amplifier (LNA) with high gain, stability, and a low noise figure.
M. Reza Hidayat   +2 more
doaj   +1 more source

A 110–170 GHz Wideband LNA Design Using the InP Technology for Terahertz Communication Applications

open access: yesMicromachines, 2023
This paper proposes a low-noise amplifier (LNA) for terahertz communication systems. The amplifier is designed based on 90 nm InP high-electron-mobility transistor (HEMT) technology.
Lian Hu   +7 more
doaj   +1 more source

An Experimental Investigation of the Degradation of CMOS Low-Noise Amplifier Specifications at Different Temperatures

open access: yesMicromachines, 2022
To investigate the relationship between the specifications degradation of a low-noise amplifier (LNA) and temperature, we experimentally investigated the degradation characteristics of the specifications of the LNA at different temperatures.
Shaohua Zhou, Jian Wang
doaj   +1 more source

A low noise cascaded amplifier for the ultra-wide band receiver in the biosensor

open access: yesScientific Reports, 2021
This paper presents the design of an Ultra-Wide Band (UWB) Low Noise cascaded Amplifier (LNA) used for biomedical applications. The designed structure uses a technique which is based on the inductances minimization to reduce the LNA surface while ...
Maissa Daoud   +2 more
doaj   +1 more source

Concurrent Dual-Band Inverter-Based Low Noise Amplifier (LNA) for WLAN Applications

open access: yesInformacije MIDEM - Journal of Microelectronics, Electronic Components and Materials, 2021
low noise amplifier (LNA); concurrent; dual-band; inverter-basedIn this paper, a two-stage concurrent dual-band low noise amplifier (DB-LNA) operating at 2.4/5.2-GHz is presented for Wireless Local Area Network (WLAN) applications. The current-reused structure using resistive shunt-shunt feedback is employed to reduce power dissipation and achieve a ...
Abolfazl Bijari   +2 more
openaire   +4 more sources

A Summing Configuration based Low Noise Amplifier for MPI and MPS

open access: yesCurrent Directions in Biomedical Engineering, 2018
Magnetic particle imaging (MPI) is a novel tomographic imaging modality which uses static and dynamic magnetic fields to measure the magnetic response generated by superparamagnetic iron oxide nanoparticles (SPIONs).
Malhotra Ankit, Buzug Thorsten M.
doaj   +1 more source

Analysis and design of a cocurrent dual-band CMOS low noise amplifier

open access: yesDianzi Jishu Yingyong, 2018
A concurrent dual-band low noise amplifier(LNA) targeted for WLAN IEEE 802.11 a/b/g standards is designed using 0.13 μm CMOS process. To attain the power-constrained simultaneous noise figure and input matching, cascode inductive degeneration topology is
Gao Lina, Pang Jianli
doaj   +1 more source

Home - About - Disclaimer - Privacy