Results 21 to 30 of about 862,186 (311)
Noise-optimized ultrastable low-noise current amplifier [PDF]
Review of Scientific Instruments, 2019 We have developed a noise-optimized ultrastable low-noise current amplifier (ULCA) aimed at reducing the uncertainty at low currents. It involves a thin-film resistor network with 6.75 GΩ at the high-ohmic path which reduces the noise level to 1.6 fA/Hz. Noise investigations as well as short-term and long-term stability studies were carried out.
C. Krause +3 more
openaire +2 more sources
Low-discrepancy blue noise sampling [PDF]
ACM Transactions on Graphics, 2016 We present a novel technique that produces two-dimensional low-discrepancy (LD) blue noise point sets for sampling. Using one-dimensional binary van der Corput sequences, we construct two-dimensional LD point sets, and rearrange them to match a target spectral profile while preserving their low discrepancy.
Abdalla G. M. Ahmed +7 more
openaire +3 more sources
Single Stage Low Noise Inductor-Less TIA for RF Over Fiber Communication
IEEE Access, 2021 This paper presents design, mathematical analysis, and measurement of low noise single-stage transimpedance amplifier (TIA) with scalable bandwidth using 130 nm bipolar complementary metal-oxide-semiconductor (BiCMOS) silicon-germanium (SiGe) process ...
Vijay Kumar +3 more
doaj +1 more source
Low-Noise Techniques in Detectors [PDF]
Annual Review of Nuclear and Particle Science, 1988 We concentrate in this review on the fundamentals of low-noise techniques and on understanding the limits in the charge signal measurements. Charge collection and signal formation in detectors, the origin and properties of noise, noise and amplification of charge, and detectors and signal processing are discussed. (AIP)
openaire +1 more source
Down With Noise: An Introduction to a Low-Noise Amplifier Survey
IEEE Solid-State Circuits Magazine, 2020 Numerous different circuits are created around the world on a daily basis, making it rather difficult for circuit designers to stay abreast of the latest developments. In an attempt to keep up with these new developments, researchers have compiled a number of spreadsheets that capture key designs and their features.
Leonid Belostotski, Sameep Jagtap
openaire +2 more sources
AIP Advances, 2019 The InGaAs-InAlAs-InP high electron mobility transistor (InP HEMT) is the preferred active device used in a cryogenic low noise amplifier (LNA) for sensitive detection of microwave signals. We have investigated the angular dependence of the InP HEMT when
Isabel Harrysson Rodrigues +6 more
doaj +1 more source
Appraisal of a low noise electrocardiogram
Journal of the American College of Cardiology, 1983 Two low noise electrocardiographic systems were designed to record low amplitude His-Purkinje potentials in the PR segment and delayed depolarization potentials in the ST-T segment from the body surface on a beat to beat basis. In one system, a bipolar electrode was utilized and the noise level was optimally reduced to 2 to 2.5 microV by a combination ...
El-Sherif, Nabil +3 more
openaire +2 more sources
Temporal Noise Analysis of Charge-Domain Sampling Readout Circuits for CMOS Image Sensors
Sensors, 2018 This paper presents a temporal noise analysis of charge-domain sampling readout circuits for Complementary Metal-Oxide Semiconductor (CMOS) image sensors. In order to address the trade-off between the low input-referred noise and high dynamic range, a Gm-
Xiaoliang Ge, Albert J. P. Theuwissen
doaj +1 more source
Noise thermometry at ultra-low temperatures [PDF]
Philosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences, 2013 The options for primary thermometry at ultra-low temperatures are rather limited. In practice, most laboratories are using 195 Pt NMR thermometers in the microkelvin range. In recent years, current sensing direct current superconducting quantum interference devices (DC-SQUIDs) have enabled the use of noise ...
D, Rothfuss +3 more
openaire +2 more sources
Journal of Low Power Electronics and Applications, 2023 This paper presents a capacitively coupled chopper instrumentation amplifier (CCIA) with ultra-low power consumption and programmable bandwidth for biomedical applications.
Xuan Thanh Pham +2 more
doaj +1 more source