Results 251 to 260 of about 862,186 (311)
A Ku-Band Fully Differential Low-Power High-Input P1dB Low-Noise Amplifier. [PDF]
Lee SR, Kim JH, Baek MS, Kim CY.
europepmc +1 more source
Kelvin Probe Force Microscopy in Bionanotechnology: Current Advances and Future Perspectives
Kelvin probe force microscopy (KPFM) enables the nanoscale mapping of electrostatic surface potentials. While widely applied in materials science, its use in biological systems remains emerging. This review presents recent advances in KPFM applied to biological samples and provides a critical perspective on current limitations and future directions for
Ehsan Rahimi +4 more
wiley +1 more source
A High-Sensitivity, Low-Noise, and Low-Hysteresis Tunneling Magnetoresistance Sensor Based on Structural Optimization of Magnetic Tunnel Junctions. [PDF]
Bi R +7 more
europepmc +1 more source
Transparent, metal-free PEDOT:PSS neural interfaces for simultaneous recording of low-noise electrophysiology and artifact-free two-photon imaging. [PDF]
Kim HW +16 more
europepmc +1 more source
High Consistency Ramp Design Method for Low Noise Column Level Readout Chain. [PDF]
Guo Z +6 more
europepmc +1 more source
Photonic chip-based low-noise microwave oscillator. [PDF]
Kudelin I +31 more
europepmc +1 more source
Some of the next articles are maybe not open access.
Related searches:
Related searches:
An ultralow noise preamplifier for low frequency noise measurements
Review of Scientific Instruments, 2009Low frequency noise measurements are among the most sensitive tools for the investigation of the quality and of the reliability of semiconductor devices. The sensitivity that can be obtained depends on the background noise of the low noise preamplifier coupled to the device under test (DUT) that, at very low frequencies, is dominated by flicker noise ...
CANNATA', GIANLUCA +2 more
openaire +2 more sources
Low noise and low cost neural amplifiers
2007 14th IEEE International Conference on Electronics, Circuits and Systems, 2007Extracellular neural signal acquisition requires low noise, high gain, low power, and low cost amplifiers. This paper presents amplifiers with a simple architecture that ensures a good compromise among these characteristics. We present three amplifiers based on the same architecture, in which the first stage is a differential pair, respectively based ...
Guilherme Bontorin +2 more
openaire +1 more source

