A 180 nm CMOS dual-mode LNA with current reuse and double-resonance load for 2.4 GHz and 3.1-10.6 GHz wireless communication. [PDF]
Snehitha Reddy T, Nath V.
europepmc +1 more source
A Safe and Portable CMUT Array Ultrasonic System for Bubble Sizing in Industrial Silicone Sealing Rings. [PDF]
He C +11 more
europepmc +1 more source
Related searches:
Antenna and low noise amplifier (LNA) co-design
2009 International Semiconductor Device Research Symposium, 2009In general, circuit designers and antenna designers work independently. The link between antenna and circuit is the conventional characteristic impedance in RF systems, such as 50Ω line in telecommunication circuits, or 75Ω in television systems. Noise matching and power matching are not likely to achieve simultaneously at 50Ω or 75Ω.
null Bo Yang +3 more
openaire +2 more sources
Design and simulation of high gain PHEMT low noise amplifier (LNA)
2007 International Conference on Computer Engineering & Systems, 2007This paper presents a 5.8 GHz low voltage, low power, and wide band LNA design using PHEMT transistor. The simulated LNA is a single stage with pi input and output matching circuits. The noise canceling principle and sensitivity analysis is performed for the simulated low noise amplifiers. The simulated results are compared with identical LNA published
Mohamed Rizk, Mohamed Nasar, Alaa Hafez
openaire +2 more sources
Design of a Gain-Stabilized Ka-Band Low Noise Amplifier (LNA)
2025 IEEE Microwaves, Antennas, and Propagation Conference (MAPCON)In this work, we propose a Ka-band low-noise amplifier (LNA) that employs $0.15 \mu \mathrm{m}$ GaAs pHEMT (high-electron-mobility transistor). The design achieves improved gain flatness across a broad frequency range.
null Kirti +2 more
openaire +2 more sources
Design of an Optimal Low Noise Amplifier (LNA) for Signal Boosting
2019 International Conference on Mechatronics, Remote Sensing, Information Systems and Industrial Information Technologies (ICMRSISIIT), 2019The purpose of a Low Noise Amplifier (LNA) is to amplify received signals to acceptable levels while minimizing noise. The LNA is used in communication systems to amplify very weak signals captured by an antenna. The design of an LNA in Microwave circuits requires a trade-off or careful balance of many important parameters such as Gain, Noise Figure ...
Frank Lemdi Prikutse +2 more
exaly +2 more sources
Characterization of Low Noise Amplifier (LNA) for mm-Wave Wireless Systems
International Conference on Robotics, Vision, Signal Processing and Power Applications, 2019This paper reports the technical design of millimeter wave (mm-Wave) low noise amplifier (LNA). The fast-growing wireless communication market and the necessity of a higher data rate certainly drive the radio frequency (RF) system towards the mm-Wave technology.
Mohd Fadzil bin Ain +5 more
openaire +2 more sources
Low power, high gain, low noise amplifier (LNA) for ultra wide‐band applications
AbstractOne of the important components of a receiver is the low noise amplifier (LNA). The challenges of LNA design include ability to achieve high gain, low noise figure, and better linearity at low power consumption within the required frequency.
Ayobami Iji, Xie Zhu, Michael Heimlich
openaire +2 more sources
A New Built-In Self-Test (BIST) for a RF Low-Noise Amplifier (LNA)
5th International Conference on Design & Technology of Integrated Systems in Nanoscale Era, 2010In this paper, we present a new RF built-in self test (BIST) circuit for 865–870 MHz low noise amplifiers (LNAs); The BIST and LNA circuit is designed using 0.35µm CMOS technology. The simple circuit of test that contains a RF peak detectors and two comparators brings high fault coverage.
R. Ayadi, M. Masmoudi
exaly +2 more sources
Design of a Dual-Band Low Noise Amplifier (LNA) Utilizing Positive Feedback Technique
2006 4th Student Conference on Research and Development, 2006This paper presents a dual band low noise amplifier (LNA) for 1.8 GHz DECT and 2.4 GHz WLAN applications employing positive feedback technique. This LNA exploits a positive feedback capacitor connected to a conventional cascaded inductive source degenerated LNA whereby the connection of a capacitor determines the operating frequency of the LNA.
Roslina Sidek, Sabira Khatun, S S Jamuar
exaly +2 more sources

