DEVELOPMENT OF LOW NOISE AMPLIFIER (LNA) FOR 5G WI-FI APPLICATIONS
This paper presents a wideband low noise amplifier (LNA) implemented in 0.15μm InGaAs pHEMT technology low-noise 5.15GHz-5.925GHz frequency range LNA (low noise amplifier) for 5G Wi-Fi applications. The proposed circuit is fabricated using 0.15μm InGaAs pHEMT technology, and it is powered by 3.5V supply.
Airpoint Co, Murod Kurbanov
openaire +2 more sources
A Sub‐Microsecond Switch Enabling SWIFT 23Na Imaging at 10.5 T [PDF]
ABSTRACT PurposeTo enable sodium SWIFT imaging, which is a zero‐echo time imaging technique, at ultra‐high magnetic fields through the development of custom electronics hardware, and to showcase this capability with in vivo imaging results. MethodsThe custom hardware developed consists of a high‐speed optical trigger with 10 ns resolution, an in‐bore ...
Russell L. Lagore +10 more
wiley +2 more sources
Cryogenic Characterisation of a Commercial Low-Noise Amplifier (LNA) for MKID Readout Systems [PDF]
The use of non-certified commercial electronics for cryogenic applications may be attractive due to their reduced cost and high availability, but they also carry risks related to reliability, performance, and thermal compatibility. The decision to use commercial components that are not certified for cryogenics instead of components specifically ...
Dylan E. Santos-Verzilli +4 more
openaire +2 more sources
Bimodal Q-band probehead with improved signal-to-noise ratio in pulse electron paramagnetic resonance [PDF]
In addition to the development of various resonators, the concept of a probehead equipped with an additional low-noise amplifier (LNA) is becoming increasingly popular to enhance the sensitivity of electron paramagnetic resonance (EPR) spectrometers. The
V. Denysenkov +3 more
doaj +2 more sources
Image Encoding With Blipped Gradients in an Echo Train [PDF]
ABSTRACT Purpose An MRI scanner was designed and built to encode k‐space points in the spin echoes occurring between 180∘ pulses in an echo train by using blipped B0 gradient pulses applied just prior to those spin echoes. Methods The proposed MRI scanner is a modification of an original design that used TRansmit Array Spatial Encoding (TRASE), a built‐
Logi Vidarsson, Gordon E. Sarty
wiley +2 more sources
A Compact Low-Power Chopper Low Noise Amplifier for High Density Neural Front-Ends [PDF]
This paper presents a low-power and area-efficient chopper-stabilized low noise amplifier (CS-LNA) for in-pixel neural recording systems. The proposed CS-LNA can be used in a multi-channel architecture, in which the chopper mixers of the LNA are ...
Alessandro Fava +3 more
doaj +2 more sources
Narrowband Radio Frequency CMOS Low-Noise Amplifier (LNA) Design
The aim of this coursework is to design a radio frequency CMOS low noise amplifier (LNA) for the center frequency 2.2 GHz. The amplifier should have the minimum noise figure matching and impedance matching both at the input and the ...
Assim, Ara Abdulsatar
openaire +2 more sources
Analytical Performance of Low Noise Amplifier Using Single-Stage Configuration for ADS-B Receiver
Automatic dependent surveillance-broadcast (ADS-B) is an equipment of a radar system to reach difficult areas. For radar applications, an ADS-B requires a low noise amplifier (LNA) with high gain, stability, and a low noise figure.
M. Reza Hidayat +2 more
doaj +1 more source
This paper proposes a design of a 38 GHz Low Noise Amplifier (LNA) that uses a three-stage common source inductive degeneration topology with a gain of 27 dB and noise figure of 1.78 dB using 0.1 µm GaAs pHEMT as an active device.
Lakshmi Balla +1 more
semanticscholar +1 more source
A 110–170 GHz Wideband LNA Design Using the InP Technology for Terahertz Communication Applications
This paper proposes a low-noise amplifier (LNA) for terahertz communication systems. The amplifier is designed based on 90 nm InP high-electron-mobility transistor (HEMT) technology.
Lian Hu +7 more
doaj +1 more source

