Results 21 to 30 of about 934,200 (296)

High-speed imaging and wavefront sensing with an infrared avalanche photodiode array [PDF]

open access: yes, 2015
Infrared avalanche photodiode arrays represent a panacea for many branches of astronomy by enabling extremely low-noise, high-speed and even photon-counting measurements at near-infrared wavelengths.
Atkinson, Dani   +6 more
core   +3 more sources

Ultra-Low Power, Process-Tolerant 10T (PT10T) SRAM with Improved Read/Write Ability for Internet of Things (IoT) Applications

open access: yesJournal of Low Power Electronics and Applications, 2017
In this paper, an ultra-low power (ULP) 10T static random access memory (SRAM) is presented for Internet of Things (IoT) applications, which operates at sub-threshold voltage. The proposed SRAM has the tendency to operate at low supply voltages with high
Pooran Singh, Santosh Kumar Vishvakarma
doaj   +1 more source

Lock-in detection for pulsed electrically detected magnetic resonance [PDF]

open access: yes, 2011
We show that in pulsed electrically detected magnetic resonance (pEDMR) signal modulation in combination with a lock-in detection scheme can reduce the low-frequency noise level by one order of magnitude and in addition removes the microwave-induced non ...
Alexander Schnegg   +12 more
core   +2 more sources

Noise in a CCD image sensor and the new low-noise read-out method.

open access: yesThe Journal of the Institute of Television Engineers of Japan, 1985
固体撮像素子を放送用の高画質撮像素子として適用するために, 付加ノイズ発生要因・量共に少ないCCD型の低雑音化と今後の高画質化の可能性などについて種々の検討を行った.まず, ランダムノイズと固定パターンノイズ (FPN) を分離して定量的に測定することができる分析評価法を数した.次に, 新開発の積分型相関二重サンプリング法, および遅延差雑音除去法を用いた低雑音化信号読出し回路により, ランダムノイズを暗電流のショットノイズの程度まで低減できることを示し, ノイズ低減効果の解析結果との良い一致も得た.さらに, 暗電流とFPNの温度依存性の測定結果から, FPNの主因が暗電流の画素ごとのむらによることも確かめた.これらの結果, CCD型撮像素子の今後の低雑音化には, 信号電荷読出し部のアンプノイズと,
Yasuaki Nishida   +3 more
openaire   +2 more sources

Thermal Noise Limited, Scalable Multi-Piezoresistor Readout Architecture

open access: yesProceedings, 2017
In this work we present a low noise, hardware efficient, and scalable read-out architecture for piezoresistive mechanical transducers containing multiple sensing elements.
János Radó   +4 more
doaj   +1 more source

Energy-Efficient and Variability-Resilient 11T SRAM Design Using Data-Aware Read–Write Assist (DARWA) Technique for Low-Power Applications

open access: yesSensors, 2023
The need for power-efficient devices, such as smart sensor nodes, mobile devices, and portable digital gadgets, is markedly increasing and these devices are becoming commonly used in daily life.
Sargunam Thirugnanam   +3 more
doaj   +1 more source

Noise Reduction Effect of Multiple-Sampling-Based Signal-Readout Circuits for Ultra-Low Noise CMOS Image Sensors

open access: yesSensors, 2016
This paper discusses the noise reduction effect of multiple-sampling-based signal readout circuits for implementing ultra-low-noise image sensors. The correlated multiple sampling (CMS) technique has recently become an important technology for high-gain ...
Shoji Kawahito, Min-Woong Seo
doaj   +1 more source

Statistical analysis of read-back signals in magnetic recording on granular media

open access: yesAIP Advances, 2020
The comprehensive simulation of magnetic recording, including the write and read-back process, on granular media becomes computationally expensive if the magnetization dynamics of each grain are explicitly computed. In addition, in heat-assisted magnetic
Florian Slanovc   +3 more
doaj   +1 more source

Signal-to-Noise Ratio Analysis for the Voltage-Mode Read-Out of Quartz Tuning Forks in QEPAS Applications

open access: yesMicromachines, 2023
Quartz tuning forks (QTFs) are employed as sensitive elements for gas sensing applications implementing quartz-enhanced photoacoustic spectroscopy. Therefore, proper design of the QTF read-out electronics is required to optimize the signal-to-noise ratio
Michele Di Gioia   +6 more
doaj   +1 more source

Single-ended 6T SRAM Cell with Low Power/Energy Consumption and High Stability [PDF]

open access: yesAUT Journal of Electrical Engineering, 2022
In this paper, we propose 6T cell with single-ended characteristics to achieve an improved stability, decrease energy consumption, and decrease leakage power.
Javad Mohagheghi   +2 more
doaj   +1 more source

Home - About - Disclaimer - Privacy