Results 141 to 150 of about 104,031,781 (196)

Optimisation of measurement and data analysis of time-resolved X-ray absorption spectroscopy of thin film organic semiconductors.

open access: yesFaraday Discuss
Alonso-Garcia B   +14 more
europepmc   +1 more source

DTI denoising for data with low signal to noise ratios [PDF]

open access: yes, 2005
Low signal to noise ratio (SNR) experiments in diffusion tensor imaging (DTI) give key information about tracking and anisotropy, e. g., by measurements with small voxel sizes or with high b values. However, due to the complicated and dominating impact of thermal noise such data are still seldom analysed.
Hahn, Klaus R.   +3 more
openaire   +3 more sources

Spatial Smoothing for Diffusion Tensor Imaging with low Signal to Noise Ratios [PDF]

open access: yes, 2003
Though low signal to noise ratio (SNR) experiments in DTI give key information about tracking and anisotropy, e.g. by measurements with very small voxel sizes, due to the complicated impact of thermal noise such experiments are up to now seldom analysed.
Hahn, Klaus R.   +2 more
openaire   +3 more sources

Precision of Spacecraft Doppler Tracking at Low Signal‐To‐Noise Ratios

Radio Science, 2023
AbstractThe signal‐to‐noise ratio received at Earth is typically larger than 10 dB‐Hz for radio tracking of a spacecraft in deep space, allowing a phase‐locked loop to execute reliable carrier tracking. Recently, missions have been proposed to utilize low‐gain antennas for Doppler tracking where the signal‐to‐noise ratio may be at the single‐digit (dB ...
D. R. Buccino   +8 more
openaire   +2 more sources

Time delay estimation with low signal to noise ratios

ICASSP '84. IEEE International Conference on Acoustics, Speech, and Signal Processing, 2005
Time delay estimation via cross-correlation exhibits a nonlinear phenomenon in which estimator performance deteriorates rapidly below a certain signal to noise ratio (SNR). This is a consequence of the large variances associated with estimating cross-correlation functions at low SNRs.
Yiu Tong Chan   +2 more
openaire   +2 more sources

Envelope detection at low signal-to-noise ratios

Proceedings of the IEEE, 1969
The apparent reduction in-modulation depth experienced by envelope detected signals at low input signal-to-noise ratios is calculated for two definitions of input S/N. From these results the dependence of output on input S/N over a range is determined and envelope detection threshold levels are defined.
S.A. Boctor, J.V. Hanson
openaire   +1 more source

On the Definition of Signal-to-Noise Ratio and Contrast-to-Noise Ratio for fMRI Data [PDF]

open access: yesPLoS ONE, 2013
Signal-to-noise ratio, the ratio between signal and noise, is a quantity that has been well established for MRI data but is still subject of ongoing debate and confusion when it comes to fMRI data.
Marijke Welvaert, Yves Rosseel
exaly   +3 more sources

Home - About - Disclaimer - Privacy