Results 121 to 130 of about 2,212 (228)
Grid-connected photovoltaic (PV) systems face numerous challenges during grid faults, including fault detection, synchronization, over-current protection, fluctuations in DC-link voltage, and compliance with active and reactive power requirements. This paper presents a control strategy based on finite-control set model predictive control (FCS-MPC) to ...
Ali Gholipour +3 more
openaire +1 more source
This study proposes a novel deep feedforward neural network (DFNN)-based control for voltage sag prediction and dynamic voltage restorer (DVR) integration with low-voltage ride-through (LVRT) to improve voltage stability and energy efficiency in wind ...
Mohamed A. Ahmed, Mona A. Bayoumi
doaj +1 more source
With the large-scale access of new energy sources such as wind power to the power grid, the inertia of the power system decreases, the frequency modulation ability decreases, and the dynamic performance of the phase locked loop in weak power grid ...
WU Hao, HU Pengfei, XIN Huanhai, TANG Bo
doaj +1 more source
Analysis and mitigation of PQ disturbances in grid connected system using fuzzy logic based IUPQC. [PDF]
Ravi T +4 more
europepmc +1 more source
A New Short-Circuit Current Calculation and Fault Analysis Method Suitable for Doubly Fed Wind Farm Groups. [PDF]
Yin J, Qian W, Huang X.
europepmc +1 more source
Enhancing low voltage ride through capability of grid connected DFIG based WECS using WCA-PSO tuned STATCOM controller. [PDF]
Muisyo IN, Muriithi CM, Kamau SI.
europepmc +1 more source
Optimal Design of Crowbar Resistance for DFIG Converter During Low Voltage Ride-through
As wind farms being coupled with power grid in large-scale, the new grid code is drafted to require the condition that wind turbines must have low voltage ride-through (LVRT) capability.
LIU Zhixing +3 more
doaj
A Distributed Control Scheme Using SiC-Based Low Voltage Ride-Through Compensator for Wind Turbine Generators. [PDF]
Ma CT, Shi ZH.
europepmc +1 more source
Dynamic response and low voltage ride-through enhancement of brushless double-fed induction generator using Salp swarm optimization algorithm. [PDF]
Memon A +8 more
europepmc +1 more source
Previously, conventional state estimation techniques have been used for state estimation in power systems. These conventional methods are based on steady state models. As a result of this, power system dynamics during disturbances or transient conditions are not adequately captured.
openaire +1 more source

