Results 81 to 90 of about 3,374 (183)
Numerical Simulation of Ice and Structure Interaction Using Common-Node DEM in LS DYNA
In this work, the icebreaking performance of the cone structure was investigated using a new numerical model called the common-node DEM developed within LS DYNA.
Xiaolong Bai +4 more
doaj +1 more source
The methodological recommendations of the process of improving the design of the rear underrun protective device (RUPD) are considered and described based on the results of computer simulation of tests (virtual tests) to ensure compliance with the ...
Eduard V. Lisouski +2 more
doaj
Simulation and Experimentation of Torkbuster Based on ANSYS/LS-DYNA [PDF]
The stick-slip vibration in deep hard formation is a technical bottleneck restricting the efficient use of PDC bit. In order to combat the stick-slip phenomenon during drilling in deep hard formations, we introduced the high frequency self-excited torkbuster.
openaire +1 more source
基于ANSYS/LS-DYNA的准双曲面齿轮动力学接触仿真分析
Dynamic emulate analysis of hypoid gear is operated with ANSYS/LS-DYNA software.The contact stress and deformation during the meshing process are got.The distribution of contact force is calculated when two pairs of teeth contacting simultaneously.And ...
马雪洁, 谢刚, 王小林
doaj
Calibration of Adipose tissue material properties in LS-DYNA
In this report, the development and calibration of an LS-Dyna model of adipose tissue are presented. The model is intended to capture the tissue behavior at large deformation and wide strain rates.
openaire +1 more source
Mechanical parameters and damage model of kelp based on ANSYS/LS-DYNA
Kelp is one of the most common large macroalgae in the ocean. Its presence poses a risk of propeller entanglement for ships, deep-sea exploration equipment, and other such assets.
ZHANG Zhihao +7 more
doaj +1 more source
Comprehensive Numerical Modeling of Prestressed Girder Bridges under Low-Velocity Impact
Accidental collisions involving over-height trucks that exceed vertical clearance limits and bridge superstructures frequently happen, resulting in compromised girders and potential threats to structural safety and performance.
Mohamed T. Elshazli +3 more
doaj +1 more source
Because the difference between the acceleration curve of traditional projectile structure and the measured acceleration curve is large,refining projectile structure is proposed.
JIN Shu-yun +2 more
doaj
Numerical and statistical analysis of aluminum deep drawing using LS-DYNA coupled with Taguchi design and response surface methodology. [PDF]
Shamso E, El Kafy MA, Naeim N.
europepmc +1 more source
Analysis of the impact of vertical deep hole blasting at the bottom of the hole on the lower ore body based on LS-dyna numerical simulation. [PDF]
Wang S +5 more
europepmc +1 more source

