Effects of an on line bypass oil recycler on emissions with oil age for a bus using in service testing [PDF]
, 2001 A method of cleaning lubricating oil on line was investigated using a fine bypass particulate filter followed by an infra red heater. Two bypass filter sizes of 6 and 1 micron were investigated, both filter sizes were effective but the one micron ...
Andrews, G.E. +4 more
core +1 more source
EHL Oil Film Behavior of Thermo-Reversible Gel-Lubricants
Tribology Online, 2008 This study investigates about the characteristic of the thermo-reversible gel-lubricant (TR Gel-Lube) under elastohydrodynamic lubrication (EHL) conditions. TR Gel-Lube is the lubricant, which consists of base fluid and a gel agent.
Daisuke Tominaga +4 more
doaj +1 more source
Gas Turbine Bearing Temperature Monitoring via Regression Modelling
ABUAD Journal of Engineering Research and Development, 2023 This paper focuses on using Regression technique (MLR) towards finding solution to incidence of high compressor bearing temperature on one of the units at Geregu power plant in Ajaokuta, Nigeria.
Abubakar Kandi MOHAMMED +2 more
doaj +1 more source
Experimental assessment of regenerated lube oil in spark-ignition engine for sustainable environment
Advances in Mechanical Engineering, 2020 Lube oils are the viscous petroleum products used in automobiles to reduce the friction. The eventual fate of lube oil is either incineration or dumping off into ground, but these resources cannot be disposed off easily due to their libellous effects on ...
Muhammad Usman +8 more
doaj +1 more source
Nylon 6,6 Nonwoven Fabric Separates Oil Contaminates from Oil-in-Water Emulsions. [PDF]
PLoS ONE, 2016 Industrial oil spills into aquatic environments can have catastrophic environmental effects. First responders to oil spills along the coast of the Gulf of Mexico in the southern United States have used spunbond nylon fabric bags and fences to separate ...
Ryan A Ortega +2 more
doaj +1 more source
Implementation of optimal oil flushing methodology for nuclear steam turbo generator oil circuits
SN Applied Sciences, 2023 The first turning gear operation is regarded as a significant milestone in the overall activities of Turbine Generator system commissioning. To accomplish this critical goal, the lube oil circuit must be clean and free of all type of contaminants.
Kudiyarasan Swamynathan +2 more
doaj +1 more source
Investigating the Effect of Temperature, Molar Ratio of Ethylene Glycol to Oil, and Catalyst Amount on BioLube Production Yield of Neem Seed Oil [PDF]
Iranian Journal of Chemistry & Chemical Engineering, 2022 Excessive use of petroleum-based lubricants and their hazardous disposal has increased environmental pollution; hence the need for eco-friendly lubricants has been increased to meet the requirements of industry and automotive.
Nadia Khan +3 more
doaj +1 more source
Propulsion and Power Research, 2019 In a gas turbine power plant, the lubrication oil must be hot enough for the turbine start-up where the unit is in standstill mode. Currently, the strategy to heat the lubrication oil of ANSALDO V94.2 gas turbine power plant is operating the units in ...
H. Hasannejad +2 more
doaj +1 more source
Lube Oil Performance Enhancement Using Nano-Polymers Additives during Copolymerization Reaction
Iraqi Journal of Industrial Research, 2023 Under the parameters of normal engine operation, lubricating oil typically experience periodic shifts in its viscosity. Because of this, engine oils often include polymeric additives that are referred to as viscosity modifiers.
Mustafa M. Hathal +3 more
doaj +1 more source
Pengaruh oli bekas terhadap sifat karet riklim dan kualitas vulkanisatnya
Majalah Kulit, Karet, dan Plastik, 2005 The objective of the research was to study the effect of the used-lube oils as reclaiming oil on the production of reclaim from waste rubber of tyre-retreading industry and quality of its vulcanizate.
Dwi Wahini Nurhajati
doaj +1 more source