Results 71 to 80 of about 3,436 (264)
This report is related to the development of a magnetic journal bearing which can support a rotating shaft without any mechanical contact. A complete levitation is successfully achieved by means of a combination of permanent magnets and servo-controlled electromagnets. The principle and the characteristics of this bearing are as follows.
SHIMIZU, Hisaji, TANIGUCHI, Osamu
openaire +2 more sources
Actuators for Active Magnetic Bearings
The literature of active magnetic bearing (AMB) technology dates back to at least 1937 when the earliest work that clearly describes an active magnetic bearing system was published by Jesse Beams [...]
Eric H. Maslen
doaj +1 more source
Global Rather Than Vertical‐Selective Saccadic Abnormalities in Progressive Supranuclear Palsy
ABSTRACT Objective To test whether vertical saccades are preferentially affected in Progressive Supranuclear Palsy (PSP). Methods PSP patients (n = 24) were compared to age‐matched controls (n = 94) and two degenerative groups (Alzheimer's disease, n = 20; Lewy body disease, n = 50).
Duy Duan Nguyen +6 more
wiley +1 more source
From Adult to Adolescent: Alignment in Clinical Trials and Outcomes in Axial Spondyloarthritis
Spondyloarthritis (SpA) is a group of chronic inflammatory diseases encompassing axial and peripheral forms, with up to 20% of patients developing symptoms before age 16. Despite this substantial pediatric burden, treatment options for juvenile‐onset SpA (JSpA), particularly those with axial disease (axJSpA), remain limited.
Pamela F. Weiss +9 more
wiley +1 more source
Comparison of Different Actuator Concepts for Applications in Rotating Machinery
Considerable improvements of machines can be expected in the near future through the use ofelectronics in combination with control techniques. A key position will be held by the actuator systems that finally have to accomplish the controlled energy ...
Heinz Ulbrich
doaj +1 more source
This article proposes a convergent adaptive observer for a damped wave PDE and an infinite‐dimensional ODE coupled in cascade using sampled‐in‐space ODE state measurements. The proposed observer estimates the distributed states of the PDE and ODE along with unknown PDE parameters and spatial input.
Zehor Belkhatir +2 more
wiley +1 more source
ErB4 and NdB4 nanostructured powders are produced by mechanochemical synthesis. 5 h mechanical alloying and 4 M HCl acid leaching are used in the production. ErB4 and NdB4 powders exhibit maximum magnetization of 0.4726 emu g−1 accompanied with an antiferromagnetic‐to‐paramagnetic phase transition at about TN = 18 K and 0.132 emu g−1 with a maximum at ...
Burçak Boztemur +5 more
wiley +1 more source
Fault Detection in Active Magnetic Bearings Using Digital Twin Technology
Active magnetic bearings (AMBs) are widely used in different industries to offer non-contact and high-velocity rotational support. The AMB is prone to failures, which may result in system instability and decreased performance.
Yefa Hu, Omer W. Taha, Kezhen Yang
doaj +1 more source
A flexure‐based variable stiffness structure is developed by integrating phase‐change modulation and adhesive interfacial locking of gallium. The design enables a wide stiffness variability, transitioning from soft, flexible behavior to rigid, load‐supporting performance.
Sungjin Kim +2 more
wiley +1 more source
Stabilization of whirl instability by floppy, viscous bearing mounts is discussed and required material properties are estimated for the new tilt-whirl mode in eddy-current stabilized magnetic bearings. A relatively low Young`s modules Y {approximately} 10{sup 5} and high viscosity {zeta} {approximately} 10{sup 7} are required (both in MKS units ...
openaire +2 more sources

