Results 221 to 230 of about 3,154,582 (307)

CO2‐to‐CO Conversion in a Gas‐Fed, Zero‐Gap, PEM Electrolyzer Enabled by Polycations and Nitrogen‐Doped Carbon‐Supported Cobalt Nanoparticles

open access: yesAdvanced Functional Materials, EarlyView.
A gas‐fed, zero‐gap, PEM CO2 electrolyzer is realized by incorporating PDDA+ ions onto the carbonaceous Co/N‐C electrocatalyst, with gaseous H2 and CO2 fed into the anode and cathode, respectively. Operating without an aqueous electrolyte, the system sustains a peak FECO of 65.1% at 100 mA cm−2. ABSTRACT Electrochemical carbon dioxide reduction (ECO2R)
Yuen Leong Chow   +6 more
wiley   +1 more source

Physics‐Grounded Materials Artificial Intelligence for Reliable Materials Discovery

open access: yesAdvanced Functional Materials, EarlyView.
Physics‐Grounded Materials AI (PhysMat AI) integrates physical priors, descriptors, constraints, verification, and data infrastructure into a unified full‐stack framework, enabling reliable, interpretable, and autonomous AI‐driven materials discovery.
Yuhang Wang   +3 more
wiley   +1 more source

Embedded Direct Ink Writing of Thermoset and Elastomeric Polymers via Frontal Polymerization

open access: yesAdvanced Functional Materials, EarlyView.
Embedded frontal polymerization direct ink writing (FP‐DIW) combines frontal ring‐opening metathesis polymerization with embedded 3D printing to decouple deposition from curing. A yield‐stress support bath stabilizes low‐viscosity inks, while on‐demand thermal initiation enables controlled front propagation. This approach expands the accessible feature
Mohammad Tanver Hossain   +12 more
wiley   +1 more source

Study of nanoparticle morphology effect on fluid flow between two active parallel plates. [PDF]

open access: yesDiscov Nano
Punith Gowda RJ   +4 more
europepmc   +1 more source

Hydrogel‐Based 3D‐Printed Anthropomorphic Breast Phantom for Emulating Mechanical and Dielectric Properties of Mammary Tissue. Applications in Microwave Imaging

open access: yesAdvanced Functional Materials, EarlyView.
A 3D‐printable breast phantom is developed using patient‐derived MRI data and hydrogels that replicate the dielectric properties of healthy and cancerous tissues. Mechanical and dielectric characterization confirm its suitability for microwave imaging.
Carlos M. Andreu   +5 more
wiley   +1 more source

Confinement in Metal‐Organic Frameworks as a Route to Harnessing Liquid Barocalorics in the Solid‐State

open access: yesAdvanced Functional Materials, EarlyView.
Encapsulation of solid–liquid barocalorics (BC) within MOFs harnesses their colossal BC performance whilst allowing active control of BC properties through BC‐MOF interactions. ABSTRACT Barocaloric (BC) effects at liquid–vapor transitions in hydrofluorocarbons drive most commercial technologies used for heating and cooling in the heating, ventilation ...
Ming Zeng   +8 more
wiley   +1 more source

A Comparison of Tissue Property Values Estimated Using Conventional Cardiac MRF and MT-Cardiac MRF. [PDF]

open access: yesMagn Reson Med
Kaplan S   +7 more
europepmc   +1 more source

Home - About - Disclaimer - Privacy