Results 11 to 20 of about 29,208 (250)
Design of a submarine main ballast blowing systems
A submarine ballast system represents a combination of dedicated equipment and piping in which the main circulating fluid is either sea water straight from the submarine exterior or air which is compressed at high pressures and then it is stored in pressure vessels onboard.
Emilian Octavian Ivanov +1 more
openaire +2 more sources
Optimization on the jet characteristics of the main nozzle of hot-blowing snow removal device
The exhaust devices used by snow removal vehicles are mainly based on hot-blowing snow removal. Due to the inherent characteristics of the turbojet engine such as low flow rate and high exhaust temperature, the modified hot-blowing snow removal device has problems of low snow removal efficiency and the possibility of ablation and damage to the road ...
Qingrui Yu +4 more
openaire +1 more source
Dynamic Modeling of the Main Blow in Basic Oxygen Steelmaking Using Measured Step Responses [PDF]
In the control and optimization of basic oxygen steelmaking, it is important to have an understanding of the influence of control variables on the process. However, important process variables such as the composition of the steel and slag cannot be measured continuously. The decarburization rate and the accumulation rate of oxygen, which can be derived
Kattenbelt, Carolien, Roffel, B.
openaire +1 more source
In this article, we consider a system of nonlinear heat equations with viscoelastic terms and Robin-Dirichlet conditions. First, we prove existence and uniqueness of a weak solution.
Le Thi Phuong Ngoc, Nguyen Thanh Long
doaj +3 more sources
Particulate emission from internal combustion engines is a complex phenomenon that needs to be understood in order to identify its main factors. To this end, it appears necessary to study the impact of unburned gases, called blow-by gases, which are ...
Vincent Berthome +2 more
doaj +1 more source
Blowing Bubbles around Intermediate-Mass Stars: Feedback from Main-Sequence Winds is not Enough
17 pages, 5 figures.
Rosen, Anna L. +3 more
openaire +2 more sources
Bifurcation and blow-up results for equations with $p$-Laplacian and convex-concave nonlinearity
This paper is concerned with the existence of global, blow-up and bifurcation solutions for parametrized families of elliptic and parabolic equations with $p$-Laplacian and concave-convex nonlinearity.
Yavdat Ilyasov
doaj +1 more source
Blow-Up Rate Estimates for a System of Reaction-Diffusion Equations with Gradient Terms
This paper is concerned with the blow-up properties of Cauchy and Dirichlet problems of a coupled system of Reaction-Diffusion equations with gradient terms. The main goal is to study the influence of the gradient terms on the blow-up profile.
Maan A. Rasheed +2 more
doaj +1 more source
Beam size blow-up and current loss in the Fermilab main ring during storage [PDF]
Observations at Fermilab during the storage mode of operation show characteristic forms of transverse beam size growth and current loss with time. There are three obvious mechanisms which can produce such blowup. The gas pressure is a source for immediate beam loss by direct nuclear scattering. Protons can also multiple Coulomb scatter off the orbiting
Guignard, G., Month, M.
openaire +2 more sources
ObjectiveIn order to study the blowing and drainage performance of a submarine main ballast tank system, the simulation and experiment of main ballast blowing based on the short circuit blowing model are carried out. MethodsFirst, the short circuit blowing model is modified to simulate the process of air release and water drainage. Next, an equal scale
Qi YI +5 more
openaire +1 more source

