Results 81 to 90 of about 54,201 (264)
Powder metal processing provides scalable advantages in nanoporous (np) metal development. Mechanical alloying is used to produce unique precursors for hybrid nanopore formation by oxide reduction and dealloying. As demonstrated in np Ag, this approach improves process efficiency while promoting smaller ligaments and larger pores, both of which are ...
Mark A. Atwater, Oliver A. Fowler
wiley +1 more source
The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar +2 more
wiley +1 more source
Manganese batteries garnered significant attention as sustainable and cost‐effective alternatives to lithium‐ion batteries. For the first time, manganese batteries are demonstrated using a manganese hexacyanoferrate cathode and organic electrolyte ...
Jangwook Pyun +7 more
doaj +1 more source
This work, first of all, reports the synthesis and structural elucidation of a schiff base ligand and its Co(II), Ni(II)and Mn(II) coordination compounds using various spectroscopic methods.
Selma Bal
doaj +1 more source
High‐frequency (HF) welding of steel is limited by oxide inclusions that degrade weld quality. This study demonstrates, for the first time, the integration of a nonthermal Ar/H2 dielectric barrier discharge (DBD) plasma jet into HF welding. Local plasma treatment provides effective shielding and in‐situ oxide reduction, resulting in markedly fewer and ...
Viktor Udachin +4 more
wiley +1 more source
Use of Manganese Supplement as an Alternative to Oral Contrast Agents for Gastrointestinal Tract Magnetic Resonance Imaging [PDF]
Introduction: This research aims to find an alternative oral contrast agents that can be used in magnetic resonance imaging (MRI) of the gastrointestinal (GI) tract, this contrast agent must be with no or minimum side effects and gives a best imaging ...
zainab mankhi +2 more
doaj +1 more source
Trace additions of Sn and Sr combined with a two‐step aging treatment are shown to enhance the microstructure and performance of Al–Zr–Sc conductor alloys. Strength and electrical conductivity increase concurrently through accelerated precipitation of fine Al3(Sc, Zr) precipitates and improved dislocation resistance, offering a cost‐effective pathway ...
Quan Shao +3 more
wiley +1 more source
COMPLEX COMPOUNDS OF MANGANESE (IV) WITH BIGUANJDES
COMPLEX COMPOUNDS OF MANGANESE (IV) WITH ...
MANOJ MOFAN RAY, PRIYADARANJAN RAY
openaire +2 more sources

