A comparative effectiveness study of usual care, simple Chuna manual therapy, and complex Chuna manual therapy for the treatment of pelvic biomechanical lesions in patients with non-acute low back pain: a protocol for multicenter, randomized controlled trial. [PDF]
Park SY+15 more
europepmc +1 more source
An Injection‐Molded Modified Silicone Rubber for Cancer‐on‐Chip Applications
This study describes the characterization and application of an injection‐molded functionalized PDMS fluidic insert for the commercially available Micronit system. Modified PDMS can accommodate cell culture and is able to covalently bind proteins for long‐lasting coatings under flow‐conditions.
Ben J. Haspels+7 more
wiley +1 more source
Manual Therapy Techniques Versus Occlusal Splint Therapy for Temporomandibular Disorders: A Systematic Review with Meta-Analysis. [PDF]
Villar-Aragón-Berzosa V+7 more
europepmc +1 more source
A wireless bioelectronic ion pump platform is developed for controlled fluoxetine delivery for wound healing in a large mammal model. Over 3 days, treated wounds showed 37% greater re‐epithelialization and a 33% lower ratio of pro‐inflammatory to reparative macrophages.
Houpu Li+25 more
wiley +1 more source
Manual therapy and exercise effects on inflammatory cytokines: a narrative overview. [PDF]
Cook CE+4 more
europepmc +1 more source
Miniaturized Devices for On‐the‐Spot Generation of Small‐Diameter Vascular Grafts
An intracorporeal extrusion device is developed for on‐the‐spot generation of vascular grafts with tunable diameters spanning from 1 to 6 mm. The device uses biomimetic polymers and light, to promptly obtaining biocompatible and high‐burst pressure‐resistant grafts.
Deyanira Hernandez‐Sanchez+11 more
wiley +1 more source
Development of a basic evaluation model for manual therapy learning in rehabilitation students based on the Delphi method. [PDF]
Ziyi W, Supo Z, Białas M.
europepmc +1 more source
NUV/Blue and NIR emitting mechanoluminescent (ML) materials based on a Bi‐doped germanate compound (NYGOBx) are reported. 3D‐printing is used to fabricate complex scaffold devices from this material, suggested for use as mechanically‐activated light sources for functional illumination.
Hossein Ebrahim Hosseini+5 more
wiley +1 more source