Results 241 to 250 of about 16,072 (279)
Some of the next articles are maybe not open access.
Corrosion of Martensitic Stainless Steel Weldments
2006Abstract Martensitic stainless steels are essentially iron-chromium-carbon alloys that possess a body-centered tetragonal crystal structure (martensitic) in the hardened condition. Martensitic stainless steels are similar to plain carbon or low-alloy steels that are austenitized, hardened by quenching, and then tempered for increased ...
openaire +1 more source
Selection of Wrought Martensitic Stainless Steels
1993Abstract This article describes general welding characteristics such as weld microstructure and weldability. The correlations of preheating and postweld heat treatment practices with carbon contents and welding characteristics of martensitic stainless steels are reviewed. The article contains a table that lists the electrodes and welding
openaire +1 more source
Strain induced martensite formation in stainless steel
Metallurgical Transactions A, 1987The Conversion Electron and X-ray Mossbauer studies of the surface of Type 316 stainless steel at 400 K, 300 K, and 100 K show that both the substitutional and interstitial elements perturb the cubic symmetry at the iron site. The single peak of austenite is a superposition of at least five quadrupole split doublets whose magnitudes and intensities ...
openaire +1 more source
Automotive Mass Reduction with Martensitic Stainless Steel
SAE Technical Paper Series, 2011<div class="section abstract"><div class="htmlview paragraph">Martensitic stainless steels are ideally suited for structural components and assemblies, satisfying the requirements of high strength, toughness and corrosion resistance with ease of forming in the annealed state.
openaire +1 more source
1988
According to Gysel, Gerber and Trautwein [369] the relatively poor weldability of chromium stainless steels, their cold cracking sensitivity and the often unsatisfactory mechanical properties obtained from welded joints led at the end of the fifties to the development of low carbon martensitic chromium-nickel steels.
openaire +1 more source
According to Gysel, Gerber and Trautwein [369] the relatively poor weldability of chromium stainless steels, their cold cracking sensitivity and the often unsatisfactory mechanical properties obtained from welded joints led at the end of the fifties to the development of low carbon martensitic chromium-nickel steels.
openaire +1 more source
Martensitic transformations in ion implanted stainless steels
MRS Proceedings, 1989ABSTRACTUsing ion implantation it is possible to induce a variety of phase transformations in the surfaces of stainless steels. The implanted layer can be either amorphized, undergo an fee (γ) => bec (α') martensitic transformation, or compounds can be formed between implanted atoms and target atoms.
openaire +1 more source
Integrative oncology: Addressing the global challenges of cancer prevention and treatment
Ca-A Cancer Journal for Clinicians, 2022Jun J Mao,, Msce +2 more
exaly
Damping properties of martensitic stainless steels
Strength of Materials, 1969G. S. Krivonogov +4 more
openaire +1 more source