Performance of clay masonry veneer in wood‐stud walls subjected to out‐of‐plane seismic loads
Earthquake Engineering and Structural Dynamics, 2010 H. Okail +3 more
exaly +2 more sources
Mokslas: Lietuvos Ateitis, 2017 BIM methodology is one of the most effective solutions for the design of masonry veneer construction. BIM implementation in design of veneer facade gives a lot of advantages for architects, designers and masonry contractors.
Viačeslav Zigmund, Darius Migilinskas
doaj +1 more source
Experimental investigation of pull out strength of flexible ties in thin brick veneer layer
Engineering Structures and Technologies, 2019 The use of thin brick veneer layers for building facades becomes more popular nowadays. Using thin bricks (50−65 mm thick) instead of normal 100−120 mm thick bricks let us to save expenses up to 50% related to materials.
Robertas Zavalis, Bronius Jonaitis
doaj +1 more source
Learning from failure of a long curved veneer wall : structural analysis and repair [PDF]
, 2013 Masonry remains the most used material for enclosure and partition walls. Still, cracking often occurs in unreinforced masonry walls under service conditions and scarce information can be found about systemic approaches in real case studies.
Lourenço, Paulo B., Medeiros, Pedro
core +1 more source
THE EVOLUTION OF THE DESIGN AND CONSTRUCTION OF MASONRY BUILDINGS IN AUSTRALIA
Gestão & Tecnologia de Projetos, 2012 Masonry is a construction material which is widely used in Australia in a number of forms (fired clay, concrete, calcium silicate, natural stone, autoclaved aerated concrete) and in a wide range of both loadbearing and non-loadbearing applications.
Adrian Page
doaj +1 more source
Experimental study on the mechanical performance of steel ties for brick masonry veneers [PDF]
, 2016 Publicado em "Brick and block masonry: trends, innovations and challenges. ISBN 978-1-138-02999-6An experimental study was carried out to analyse the tension and compression behaviour of wall ties anchoring brick veneer walls to masonry infill walls as ...
Costa, A. Campos +2 more
core +1 more source
Wind load resistance of multilayer walls supported floor-by-floor with a facing layer
Инженерно-строительный журнал, 2015 The article describes a method for checking the ultimate limit state of multilayer walls supported floor-by-floor with a facing layer under wind loads.
V.N. Derkach
doaj +1 more source
Hygrothermal behaviour of timber frame walls finished with a brick veneer cladding [PDF]
, 2017 In this study, two typical timber frame walls with brick veneer cladding have been constructed at KU Leuven to investigate the hygrothermal response of these constructions in a moderate sea climate.
Langmans, Jelle +4 more
core +1 more source
Six types of enclosing structures for low-storey houses. Economic comparison
MATEC Web of Conferences, 2018 The article represents comparative economic analysis of 6 types of enclosing structures for low-storey houses. They are: masonry, foam concrete blocks laying, glued laminated lumber, timber frame construction, light-weight steel thin-walled framing ...
Ibrahimov Alexander +3 more
doaj +1 more source
Performance of masonry buildings and churches in the 22 february 2011 christchurch earthquake [PDF]
, 2011 As part of the „Project Masonry‟ Recovery Project funded by the New Zealand Natural Hazards Research Platform, commencing in March 2011, an international team of researchers was deployed to document and interpret the observed earthquake damage to masonry
Centeno, Jose +12 more
core +1 more source