Results 221 to 230 of about 2,114,654 (290)
Some of the next articles are maybe not open access.

Seismic performance of mortarless reinforced masonry walls

, 2020
Reinforced masonry walls are commonly used as a primary lateral load resisting system in buildings in regions of moderate or high seismicity. Mortarless reinforced masonry (MLRM) walls are constructed using concrete masonry units placed without mortar ...
Liang Huang   +5 more
semanticscholar   +1 more source

Strengthening unreinforced masonry walls using natural hemp fibers

Journal of Building Engineering, 2020
This paper presents an experimental setup to study the effectiveness of using natural hemp fibers for enhancing the out of plane flexural capacity of unreinforced masonry walls.
R. Bitar   +4 more
semanticscholar   +1 more source

On the out-of-plane flexural design of reinforced masonry walls

, 2020
Out-of-plane flexural capacity of masonry is enhanced due to the presence of vertical compression up to a certain level. Most international design standards include the vertical load contribution to the flexural capacity of unreinforced masonry walls ...
Sarkar Noor-E-Khuda, M. Dhanasekar
semanticscholar   +1 more source

Failure analysis of masonry walls subjected to low velocity impacts

, 2020
Masonry buildings constructed along busy roads are vulnerable to vehicular impacts. As most of these impacts are likely to occur at low velocity due to severe braking by drivers to avoid catastrophe, the present study reports a failure analysis of ...
Mohammad Asad   +3 more
semanticscholar   +1 more source

Innovative seismic strengthening of historic masonry walls using polymer mortar and steel strips

, 2020
Appropriate selection of strengthening methods for existing historic masonry structures is of utmost importance to improve the seismic behavior without altering their aesthetics.
Xianhua Yao   +3 more
semanticscholar   +1 more source

Integrated Structural and Energy Retrofitting of Masonry Walls: Effect of In-Plane Damage on the Out-of-Plane Response

, 2020
A total of 12 experiments were carried out to evaluate the effect of prior in-plane damage on the out-of-plane response of structurally and thermally retrofitted masonry wallettes, simulat...
P. Gkournelos   +2 more
semanticscholar   +1 more source

Structural behaviour and design rules of confined masonry walls: Review and proposals

Construction and Building Materials, 2019
Confined masonry (CM) has been adopted as a cost-effective and earthquake-resistant solution for buildings, mostly in developing countries. CM has large potential for use in Europe, but suitable rules for its application are not available in the European
R. Marques, P. Lourenço
semanticscholar   +1 more source

Steel Supported Masonry Walls

Engineering Journal, 1980
Structural steel beams and columns are often used to support masonry walls subjected to transverse and axial loads. Warehouse and gymnasium type buildings often have large floor-to-ceiling heights, such that allowable masonry wall heights are exceeded.
Lawrence A. Soltis, Young-Bee Tuan
openaire   +1 more source

Experimental and numerical evaluation of reinforced dry-stacked concrete masonry walls

Journal of Building Engineering, 2019
In dry-stack concrete masonry systems, masonry units are laid without mortar joints, reducing the cost and the time required for construction. Despite these advantages, mortarless construction has not been widely implemented, which is attributed to the ...
M. Martínez, S. Atamturktur
semanticscholar   +1 more source

Home - About - Disclaimer - Privacy