3D‐Printed Actuator Powered by Liquid Crystal Elastomer Muscles at the Water–Air Interface
Soft robots for unstructured environments require responsive, durable actuators. Liquid crystal elastomers (LCEs) provide large reversible deformations under thermal or optical stimuli. Direct ink writing enables fabrication of LCE actuators integrated with silicone, with mesogen chemistry and oligomers optimized for printable inks.
Cecilie Ryberg +5 more
wiley +1 more source
Residual Stresses and Distortion in Material Extrusion Additive Manufacturing of Reinforced Thermoplastic Composites: A Review. [PDF]
Goryl K, Vodilka A, Kočiško M.
europepmc +1 more source
Extrusion‐Based Bioprinting of Living Bioinks for Tissue and Organ Engineering
Extrusion‐based bioprinting is presented as the most versatile route for fabricating living, heterogeneous tissues. Its ability to combine diverse bioinks, support matrices, and advanced printhead geometries transforms familiar constraints into powerful biofabrication opportunities.
Eric Silberman +4 more
wiley +1 more source
Comparative Study of Machine Learning Models for Optimal Prediction of Printed-Line Features in Material Extrusion Additive Manufacturing. [PDF]
Shen S, Chen R, Sun W, Zhao M, Zhang H.
europepmc +1 more source
A Review on Microstructural Formations of Discontinuous Fiber-Reinforced Polymer Composites Prepared via Material Extrusion Additive Manufacturing: Fiber Orientation, Fiber Attrition, and Micro-Voids Distribution. [PDF]
Wang Z, Fang Z, Xie Z, Smith DE.
europepmc +1 more source
Low‐Outgassing Liquid Metal–Silicone Composites for Multifunctional Space Applications
Integrating liquid metal microdroplets into a space‐grade silicone creates a multifunctional composite while preserving its inherent flexibility and low‐outgassing behavior. The composite has 11×$\times$ higher thermal conductivity while remaining thermally stable and maintaining a total mass loss of ≤$\le$ 1% under thermal vacuum testing.
Spencer Pak +5 more
wiley +1 more source
Composition consistency as a critical quality attribute for material extrusion additive manufacturing. [PDF]
Hilger L, Marnot A, Brettmann B.
europepmc +1 more source
Red‐Light Tomographic Volumetric 3D Printing in Seconds for Fabrication of Colorless Structures
A custom red‐light‐responsive TVAM platform combines methylene blue, triethanolamine, and PEGDA to fabricate transparent crosslinked hydrogels. Light patterns are projected into a rotating resin container, where a sacrificial photoinitiator system enables rapid polymerization and colorless channel‐containing structures, utilizing low‐energy light for ...
Ali Eftekhari +9 more
wiley +1 more source
Development and Characterization of Thermomechanically Treated and Untreated Banana Rachis Fiber/PLA Composites for Material Extrusion Additive Manufacturing. [PDF]
Monzón E +4 more
europepmc +1 more source
Print Velocity Effects on Strain-Rate Sensitivity of Acrylonitrile-Butadiene-Styrene Using Material Extrusion Additive Manufacturing. [PDF]
Verbeeten WMH +2 more
europepmc +1 more source

