Results 231 to 240 of about 2,982,518 (386)

Physics-informed modeling of splitting tensile strength of recycled aggregate concrete using advanced machine learning. [PDF]

Sci Rep
Onyelowe KC, Kamchoom V, Hanandeh S, Anandha Kumar S, Zabala Vizuete RF, Santillán Murillo RO, Zurita Polo SM, Torres Castillo RM, Ebid AM, Awoyera P, Arunachalam KP.   +10 more
europepmc   +1 more source

Fabrication of boron nitride/copper oxide@multi-walled carbon nanotubes composites for enhancing heat transfer and photothermal conversion of phase change materials

Arabian Journal of Chemistry
To realize the efficient storage and conversion of solar energy by phase change materials (PCMs), low photothermal conversion efficiency and poor heat transfer performance remain great challenges.
Weifang Han, Deyi Liu, Guoliang Wang, Suliang Li, En You, Zhengfeng Jia, Yuchao Li   +6 more
doaj  

Sustainable engineering of rammed earth construction. Material, design and performances optimization

, 2023
Giada Giuffrida
openalex   +1 more source

Risk Analysis on the Equipment and Material Procurement Process of Engineering, Procurement, and Construction (EPC) Projects

, 2020
Mohammed Ali Berawi, Aryartha Soepardi, Mustika Sari   +2 more
openalex   +2 more sources

Monte Carlo modeling of radiation dose from radiation therapy with superficial x‐rays

Journal of Applied Clinical Medical Physics, EarlyView.
Abstract Introduction Superficial x‐rays (50–100 kVp) are used for treating non‐melanoma skin cancer and intraoperative radiation therapy (IORT). At these energies, the photoelectric effect significantly increases absorbed dose to bone compared to soft tissue.
Reham Barghash, Tiffany W. Martin, Amber R. Prebble, Del Leary   +3 more
wiley   +1 more source

Influence of Pavement Material and Structure on Low-Temperature Crack Resistance for Double-Layer Asphalt Surface One-Time Paving. [PDF]

Materials (Basel)
Wu B, Han Z, Mao Y, Wang S, Zhao H, Zhang S, Li M.   +6 more
europepmc   +1 more source

Ideological and Political Construction and Evaluation of Basic Courses of Materials Science and Engineering

, 2020
Deqiang Liao
openalex   +2 more sources

Effects of simultaneous multislice acceleration on the stability of radiomics features in parametric maps of IVIM and DKI in uterine cervical cancer

Journal of Applied Clinical Medical Physics, EarlyView.
Abstract Purpose The aim of this study was to investigate the influence of the simultaneous multislice acceleration (SMS) technique as well as two‐dimensional (2D) and three‐dimensional (3D) tumor segmentations on radiomics features (RFs) within the parametric maps of cervical cancer, which were computed by intravoxel incoherent motion (IVIM) and ...
Shuangquan Ai, Wei Peng, Rong Hou, Huiting Zhang, Robert Grimm, Zilong Yuan, Yulin Liu   +6 more
wiley   +1 more source

Enhancing energy efficiency in buildings using sawdust-based insulation in hot arid climates. [PDF]

Sci Rep
Alwan NT, Tarish AL, Yaqoob SJ, Bajaj M, Zaitsev I.   +4 more
europepmc   +1 more source

Development of a generic focal spot measurement method suitable for bore‐type linacs

Journal of Applied Clinical Medical Physics, EarlyView.
Abstract Purpose In linear accelerators, deviations in the x‐ray focal spot position significantly affect the accuracy of radiation therapy. However, as the focal spot position in bore‐type linac systems such as the Radixact system, cannot be assessed using conventional methods, a new evaluation method is required.
Hidetoshi Shimizu, Kazuharu Nishitani, Tomoki Kitagawa, Koji Sasaki, Takahiro Aoyama, Takeshi Kodaira   +5 more
wiley   +1 more source