Results 81 to 90 of about 149 (149)

High‐throughput Photocatalytic Reactor With in Operando Characterisation for Fast Screening of Materials for the Photodegradation of Water‐Borne Pollutants

Advanced Materials Interfaces, EarlyView.
A novel fast‐screening photocatalytic reactor system (FaS‐PhoReS) using terrestrial sunlight is able to measure the in operando photodegradation of 32 samples at once, and does not suffer from the common problem of sample evaporation. Four photostable 12 dyes are used to investigate the photocatalytic performance of TiO2 and ZnO samples in both film ...
Elisante Maloda Maloda, Likius Shipwiisho Daniel, Dmitry Busko, Andrey Turshatov, Justine Sageka Nyarige, Bryce Sydney Richards   +5 more
wiley   +1 more source

Scaled‐Up Graphene Growth Through Chemical Vapor Deposition Over Large‐Area Liquid Cu Catalysts

Advanced Materials Interfaces, EarlyView.
Scaling up the catalyst area fivefold and improving molten catalyst cleaning minimize reactor kinetic effects, enabling reaction kinetics to dominate graphene growth. This results in high‐quality graphene with controlled layering and measurable nucleation rates.
Mahesh K. Prabhu, Christos Tsakonas, Yilei Tian, Marc de Voogd, Kees E. Kolmeijer, Anastasios Manikas, Gertjan van Baarle, Grégory F. Schneider, Costas Galiotis, Irene M. N. Groot   +9 more
wiley   +1 more source

Ultra‐Flexible µ‐ECoG Arrays Based on PEDOT:PSS Micropillars

Advanced Materials Interfaces, EarlyView.
This work demonstrates an efficient procedure for fabricating ultra‐flexible neural interfaces endowed with micropatterned microelectrodes to increase surface area and characterized by extremely low impedance values to enable high‐quality recordings. The home‐built device has been shown to record somatosensory evoked potentials in vivo with exceptional
Alice Lunghi, Michele Bianchi, Pierpaolo Greco, Riccardo Viaro, Michele Di Lauro, Luciano Fadiga, Fabio Biscarini   +6 more
wiley   +1 more source

Antifouling PEG Coatings by Thiol‐Acrylate Conjugate Addition Reactions for Generation of Protein Patterns via Photobleaching‐Induced Protein Binding (PiPB) BioBitmaps Using Maskless Projection Lithography

Advanced Materials Interfaces, EarlyView.
Homo‐bifunctional PEG, acrylate‐PEG‐acrylate (PEGDA), coatings are prepared on glass and glass‐type surfaces using solvent‐free thiol‐acrylate conjugate addition reactions at room temperature. The prepared PEGDA coatings are stable, antifouling, and provide feature terminal acrylates that can act as free radical acceptors for photobleaching‐induced ...
Ali Usama, Evelin Schäfer, Pang Zhu, Qingchuan Song, Alexander Weißbach, Dorothea Helmer, Joachim Wollschläger, Changjiang You, Martin Steinhart, Pegah Pezeshkpour, Peilong Hou, Bastian E. Rapp   +11 more
wiley   +1 more source

Electrochemically Modified Mn₂P₄O₁₂ as an Emerging Catalyst for Oxygen Evolution Reaction

Advanced Materials Interfaces, EarlyView.
Mn₂P₄O₁₂ nanomaterials derived from MnO₂ nanosheets, act as pre‐catalysts and undergo in situ surface reconstruction during alkaline OER. The transformation yields MnO₂ and restructured Mn₂P₄O₁₂ phases, forming efficient active sites. This work highlights cyclotetraphosphate‐based catalysis and introduces a cost‐effective, stable material for enhanced ...
Kassa Belay Ibrahim, Tommaso Michelutti, Alessandro Gradone, Mahnoor Hassan, Sandro Zorzi, Paolo Moras, Vittorio Morandi, Elisa Moretti, Tofik Ahmed Shifa, Alberto Vomiero   +9 more
wiley   +1 more source

Magnetoelastic Sensing: A Study of Flexible Magnetoelastic Strain Sensors for Highly Deformed Posture Perception

Advanced Materials Technologies, EarlyView.
This study proposes a magnetoelastic strain sensor for highly deformed posture perception. The sensor can maintain stable sensing signal output under significant strain (200%) and at varying stretch rates (ranging from 1000 to 8000 mm min−1). The sensor design is simple and can be applied to soft robots and wearable devices.
Jing Shu, Junming Wang, Yujie Su, Minghao Liu, Yehui Li, Hsuan‐Yu Lu, Md Masruck Alam, Chun‐Hang Eden Ti, Shuk Fan Tong, Zhaoli Gao, Zhao Guo, Zheng Li, Raymond Kai‐yu Tong   +12 more
wiley   +1 more source

Flexible Production of Spherical Powders of Ti‐V‐Zr‐Nb‐Mo‐Hf‐Ta‐W Refractory High‐Entropy Alloys by Plasma‐Assisted Centrifugal Atomization

Advanced Materials Technologies, EarlyView.
In this work, spherical powders of refractory Ti‐V‐Zr‐Nb‐Mo‐Hf‐Ta‐W high‐entropy alloys (R‐HEAs) have been fabricated in a single step by plasma‐assisted centrifugal atomization. Loss of the heaviest elements in the composition is observed only at rotational speeds higher than 13 000 rpm due to solid‐solid centrifugal separation.
Marina Ciurans‐Oset, Johanne Mouzon, Farid Akhtar   +2 more
wiley   +1 more source

Optimal Control in the Mathematical Model of Internal Waves

Journal of Computational and Engineering Mathematics, 2020
K.Yu. Kotlovanov, E.V. Bychkov, A.V. Bogomolov   +2 more
openaire   +1 more source

Numerical and Experimental Study of High‐Speed Laser Cutting of Copper Current Collectors: Process Optimization for Quality Assessment

Advanced Materials Technologies, EarlyView.
This study employs a CFD model to simulate laser cutting of copper current collectors used for Li‐Ion battery production. This model predicts cut edge quality by assessing the influence of power, scanner speed, and foil thickness. Defects are classified and an optimal working area is found.
Caterina Angeloni, Samuele Piandoro, Erica Liverani, Alessandro Fortunato   +3 more
wiley   +1 more source

Mathematical Analysis of Optimal Control Theory on Underweight

Advances in Research, 2016
Bijal M. Yeolekar, Nita H. Shah, Foram A. Thakkar   +2 more
openaire   +2 more sources