Results 281 to 290 of about 233,669 (326)

Theory on the determination of the dynamic surface tension with the drop volume and maximum bubble pressure methods

Journal of Colloid and Interface Science, 1981
P. Joos, E. Rillaerts
openalex   +2 more sources

Some of the next articles are maybe not open access.

Related searches:

Measurement of the surface tension of electrolytic copper by the maximum gas bubble pressure method

Bulletin of the Academy of Sciences, USSR Division of Chemical Science, 1964
1. The surface tension of electrolytic copper at 1600° has been measured and found to be 1230 dyne/cm. 2. The possibility has been shown of experimentally confirming the correctness of the use of external radii in calculating a from Cantor's formula or from Sugden's formula in the investigation of non-wetting liquids.
V. I. Yashkichev, V. B. Lazarev
openaire   +1 more source

Dynamic Surface Tension of Ionic Liquid [C₁₀(EP_y)₂]Br₂ Using Maximum Bubble Pressure Method

, 2012
Dahye La, Amuthan Chinnappan, Hern Kim
openalex   +2 more sources

Application of the maximum bubble pressure technique for dynamic surface tension studies of surfactant solutions using the Sugden two-capillary method

Journal of Colloid and Interface Science, 2006
Exact knowledge of the dead time as part of the bubble lifetime in the maximum bubble pressure method is an important prerequisite for accurate dynamic surface tension measurements. The duration of the dead time depends essentially on the capillary geometry and affects significantly the measured surface tensions of concentrated surfactant solutions ...
Fainerman, V., Mys, V., Makievski, A., Miller, R.   +3 more
openaire   +3 more sources

Dynamic of soluble adsorption layer studied by a maximum bubble pressure method in the µs and ms range of time

2007
The MPT1 allows to determine the bubble dead time and to calculate the effective surface age of a bubble. The developed theory for describing adsorption processes at the surface of a growing bubble and useful approximate solutions of this theory give access to a quantitative interpretation of experiments.
Miller, R., Fainerman, V., Joos, P.
openaire   +2 more sources

Magnetic resonance linear accelerator technology and adaptive radiation therapy: An overview for clinicians

Ca-A Cancer Journal for Clinicians, 2022
William A Hal, X Allen Li, Daniel A Low
exaly  

The Thermophysical Properties of Liquid TRIP/TWIP‐Steel Alloys Using the Maximum Bubble Pressure Method

, 2013
T. Dubberstein, H. Heller
semanticscholar   +1 more source

Surface tension measurement of molten SiO 2 -Na 2 O-NaF system in wide composition range by maximum bubble pressure method

, 2021
Osamu Takeda
openalex  

The measurement of surface tension of liquid aluminium by means of the maximum bubble pressure method: The effect of surface oxidation

, 1984
A. Pamies, C. Cordovilla, E. Louis
semanticscholar   +1 more source

Comments on "Measurement of Interfacial Dilatational Viscosity at High Rates of Interface Expansion Using the Maximum Bubble Pressure Method," by R. L. Kao, D. A. Edwards, D. T. Wasan, and E. Chen

, 1993
Kostas S. Avramidis
openalex   +1 more source