Results 131 to 140 of about 199,112 (153)
Method of calculating the maximum transmission capability with unified power flow controller
Journal of Engineering, 2017 This study proposed an algorithm for calculating the maximum transmission capacity considering unified power flow controller (UPFC). At the beginning, the equivalent virtual generator, located on ends of UPFC's branch, is obtained based on the source model of UPFC. Then, for the purpose of obtaining the range of transmission power, the maximum (minimum)
Liu Jiankun +4 more
exaly +2 more sources
Some of the next articles are maybe not open access.
Related searches:
Related searches:
A study of maximum power operation for engine in continuously variable transmission powertrain
2011 International Conference on Electric Information and Control Engineering, 2011The continuously variable transmission (CVT) offers much freedom in controlling the engine speed and torqueCwhich can be used to improve fuel economy by operating the engine in fuel-optimal operating points. In this paper, the engine maximum power operation modes of CVT driveline will be described entirely and respectively. The rapid control prototype (
Lin He +3 more
openaire +1 more source
Sensitivity Studies of Compensated EHV Transmission Line for Maximum Power Transfer
Electric Power Components and Systems, 2003The sensitivity analysis of EHV transmission lines compensated with series capacitors and shunt reactors is attempted to observe a priori the effects of several line parameters on load-end VAR source compensation for different loadings. The sensitivity study is also applied to the probabilistic evaluation of the load-end VAR source compensation.
null RAMALINGAM +2 more
exaly +2 more sources
Maximum efficiency synthesis of planar arrays for wireless power transmission
2013International ...
Oliveri, Giacomo +2 more
openaire +2 more sources
Maximum power transfer in AC transmission lines limited by voltage stability
Proceedings of International Conference on Power Electronics, Drives and Energy Systems for Industrial Growth, 2002Closed form expressions for the maximum power transfer, limited by voltage stability and the corresponding voltage, in AC transmission lines for constant power and constant impedance type loads are derived. The transmission line is represented by its n-equivalent model.
N.S. Raviprakasha, K. Ramar
openaire +1 more source
2020
{"references": ["Mohammad Tawhidul Alam and Q. Ahsan (2018), \"A mathematical model for the loadability analysis of a simultaneous AC\u2013DC power transmission system\", Electr. Engg., Volume 100, Issue 3, pp. 1901-1911, DOI: https://doi.org/10.1007/s00202-017-0670-8.", "P. Vijay Kumar Babu, P. Bhaskara Prasad and M.
Alam, Mohammad Tawhidul +2 more
openaire +2 more sources
{"references": ["Mohammad Tawhidul Alam and Q. Ahsan (2018), \"A mathematical model for the loadability analysis of a simultaneous AC\u2013DC power transmission system\", Electr. Engg., Volume 100, Issue 3, pp. 1901-1911, DOI: https://doi.org/10.1007/s00202-017-0670-8.", "P. Vijay Kumar Babu, P. Bhaskara Prasad and M.
Alam, Mohammad Tawhidul +2 more
openaire +2 more sources
Maximum Power Transmission Between Two Reflector Antennas in the Fresnel Zone
Bell System Technical Journal, 1971Power transfer between two ellipsoidal reflector antennas with common focal points and dual-mode feeds has been investigated. Assuming a circularly symmetric feed pattern, the H-plane pattern of an open-end circular waveguide excited by the TE 11 mode, the maximum transmission coefficient between reflector apertures is found to be within 0.5 percent ...
openaire +1 more source
4th International Symposium on Power Electronics and Control Engineering (ISPECE 2021), 2021
Fei Yu +5 more
openaire +1 more source
Fei Yu +5 more
openaire +1 more source
Multi-Target Microwave Power Transmission With Maximum Efficiency and Allocable Power Proportion
2023 XXXVth General Assembly and Scientific Symposium of the International Union of Radio Science (URSI GASS), 2023Xiao Cai, Mengchi Xu
openaire +1 more source