Results 1 to 10 of about 364 (76)

Isolated AC/AC Converter With LLC Resonant Converter High-Frequency Link and Four-Quadrant Switches in the Output Stage

IEEE Access, 2020
An AC-AC converter with a high-frequency link employing an LLC resonant converter operating in the vicinity of the resonance frequency was studied, in which a single output power stage is used, formed by a high-frequency AC-AC converter employing four ...
Leonardo F. Pacheco, Kaio C. M. Nascimento, Ivo Barbi   +2 more
doaj   +1 more source

Solid-State Transformer for Power Distribution Grid Based on a Hybrid Switched-Capacitor LLC-SRC Converter: Analysis, Design, and Experimentation

IEEE Access, 2020
A solid-state transformer (SST) is being proposed for a distribution grid of 13.8 kV/380 V. The SST is based on the input-series output-parallel (ISOP) arrangement of twelve modules using the 1.2 kV SiC switches.
Rogerio Luiz Da Silva, Victor Luiz Flor Borges, Carlos Eduardo Possamai, Ivo Barbi   +3 more
doaj   +1 more source

Suppression of Reactive Power in Isolated Modular Multilevel DC–DC Converter Under Quasi Square-Wave Modulation

IEEE Access, 2019
An isolated modular multilevel dc-dc converter (IMMDCC) consisting of two modular multilevel converters (MMCs) coupled via a medium-frequency transformer is competitive for medium- and high-voltage applications because of its high modularity and high ...
Changjiang Sun, Xu Cai, Jianwen Zhang, Gang Shi   +3 more
doaj   +1 more source

Simulation and Modeling of a AC-DC Converter Controlled by Pulse Width Modulation Using Soft Switching topology

مجلة علوم ذي قار, 2019
  This work presents the design, analysis, and simulation of AC-DC converter topology incorporating a voltage source converter (VSC) and a direct converter, connected with medium frequency transformer isolation.
Hasanain A. hanoon
doaj   +4 more sources

An asymmetrical quadruple active bridge series resonant DC–DC converter for modular solid‐state transformers

IET Power Electronics
The DC–DC conversion stage of a three‐stage solid‐state transformer is the most challenging due to the combination of high power, medium voltage, and medium frequency. This combination also causes most of the losses in the DC–DC stage.
Saeid Khani, Seyed Hossein Hosseini, Mehran Sabahi   +2 more
doaj   +1 more source

Technical Review of PWM Techniques for Dual Active Bridge for EV Charging

Al-Iraqia Journal for Scientific Engineering Research
The need for bidirectional power flow between Electric Vehicle (EV) chargers and the grid via Vehicle-to-Grid (V2G) technology demands efficient power electronic converters.
P.B. Musiiwa, E.T. Kapuya, D. Musademba, D. Simango   +3 more
doaj   +1 more source

Transportation-oriented isolated type energy interaction converter for vehicle-to-vehicle. [PDF]

Sci Rep
Jia W, Wang R, Wei Z, Jiang C, Song Z.
europepmc   +1 more source

Reduced switch multiple active bridge DC-DC converter for modular solid-state transformers. [PDF]

Sci Rep
Khani S, Hosseini SH, Sabahi M.
europepmc   +1 more source

Performance evaluation of a series-connected step-up/down partial power converter for battery energy storage applications. [PDF]

Sci Rep
Liu Q, Jing L, Xu W, Sun R, Wu X, Lei J, Zhang Y.   +6 more
europepmc   +1 more source

Coupled inductor and switched capacitor hybrid interleaved parallel high gain converter. [PDF]

Sci Rep
Hou Y, Rong D, Sun X, Lin Z.
europepmc   +1 more source