Results 131 to 140 of about 161,009 (301)
Effect of Metal Foam Insert Configurations on Flow Boiling Heat Transfer and Pressure Drop in a Rectangular Channel. [PDF]
Materials (Basel), 2021 Nam S, Kim DY, Kim Y, Kim KC.
europepmc +1 more source
Degradation Mechanisms in PEM Water Electrolysis: Diagnosis and Impact
Advanced Materials Technologies, EarlyView.This review provides an analysis of degradation mechanisms in proton electrolyte membrane water electrolyzers (PEMWE), focusing on all key components. It discusses diagnostic and measurement techniques for evaluating degradation, less‐studied mechanisms, and an expert survey.
Annik Bernhardt +11 more
wiley +1 more source
Foam-Metal Liner Attenuation of Low-Speed Fan Noise [PDF]
, 2008 A foam-metal liner for attenuation of fan noise was developed for and tested on a low speed fan. This type of liner represents a significant advance over traditional liners due to the possibility for placement in close proximity to the rotor.
Jones, Michael G., Sutliff, Daniel R.
core +1 more source
Review and a Theoretical Approach on Pressure Drop Correlations of Flow through Open-Cell Metal Foam. [PDF]
Materials (Basel), 2021 Yang H, Li Y, Ma B, Zhu Y.
europepmc +1 more source
Magnetic Textiles: A Review of Materials, Fabrication, Properties, and Applications
Advanced Materials Technologies, EarlyView.Magnetic textiles (M‐textiles) are emerging as a programmable materials platform that merges magnetic matter with hierarchical textile structures. This article consolidates magnetic material classes, textile architectures, and fabrication and magnetization strategies, revealing structure–property–function relationships that govern magneto‐mechanical ...
Li Ke +3 more
wiley +1 more source
Insulation bonding test system [PDF]
, 1984 A method and a system for testing the bonding of foam insulation attached to metal is described. The system involves the use of an impacter which has a calibrated load cell mounted on a plunger and a hammer head mounted on the end of the plunger.
Beggs, J. M. +6 more
core +1 more source
Advanced Materials Technologies, EarlyView.A stress‐normalised sensitivity metric (S = G/Y) is introduced as a materials‐level benchmark for intrinsically piezoresistive nanocomposites. By decoupling electromechanical response (G) from stiffness (Y), the framework enables direct comparison across diverse systems and clarifies design trade‐offs for wearable sensors.
Conor S. Boland
wiley +1 more source
Manufacturing of Composites by Pressure Infiltration, Structure and Mechanical Properties [PDF]
, 2008 This paper presents the possibility of composite block production by using pressure infiltration technology. This method uses the pressure of an inert gas (usually argon or nitrogen) to force the melted matrix material to infiltrate the reinforcing ...
Dobránszky, János +2 more
core
Advanced Materials Technologies, EarlyView.A flexible piezoresistive pressure sensor with gradient toroidal CNT/PDMS microstructures is reported. The hierarchical geometry enables sequential electrode contact, achieving a sensitivity of 256.20 kPa−1 and linear response (R2 = 0.99) over 0–1000 kPa.
Rongmei Wang +8 more
wiley +1 more source
Thermal Performance Enhancement of Phase Change Materials (PCMs) by Using Metal Foams
مجلة النهرين للعلوم الهندسية, 2017 An investigation of thermal conductivity enhancement, melting and solidification processes of Phase Change Materials (PCMs) by using metal foams has been carried out.
Ihsan Y. Hussain +1 more
doaj