Results 1 to 10 of about 258,081 (165)
The development of the method for identifying the hardening curves of materials based on the results of torsion tests of notched specimens [PDF]
MATEC Web of Conferences, 2021 The article is devoted to studying the rheological properties of metals and alloys in a cold state. The method is proposed to identify the hardening curve of a material based on torsion tests of round specimens with a notch.
Erpalov Mikhail, Panin Evgeny
doaj +1 more source
Advances in Materials Science and Engineering, 2022 Based on traditional titanium-based composites and the design concept of biomimetic laminated structures, the continuous SiC ceramic fiber, ductile metal Ti foil, and intermetallic Ti2AlNb foil were selected as structural components, which were ...
Guoqing Zhang +7 more
doaj +1 more source
Crystals, 2022 This study analyses the effect of martensite grain size and its volume fraction in dual-phase (DP) steel on (1) the formability limit, (2) average global behavior under different loading conditions, and (3) damage initiation.
Tarek Hussein +4 more
doaj +1 more source
Analysis of defects in a twin roll cast Mg‐Y‐Zn magnesium alloy
Engineering Reports, 2022 Twin roll casting (TRC) enables the production of magnesium strips in an economic manner. TRC has enormous potential for the production of thin strip material from magnesium alloys. However, a range of defects may arise during casting.
Kristina Kittner +5 more
doaj +1 more source
Twin Roll Casting and Secondary Cooling of 6.0 wt.% Silicon Steel
Metals, 2021 Iron–silicon alloys with up to 6.5 wt.% Si offer an improvement of soft magnetic properties in electrical steels compared to conventional electrical steel grades.
Max Müller +3 more
doaj +1 more source
Revista de Metalurgia, 2023 Drawing is a manufacturing process that consists of indirect deformation by pulling the material through a tool with a conical geometry. The process is usually performed at room temperature (cold forming), so the selection of effective lubricants is ...
Thomas Gomes dos Santos +6 more
doaj +1 more source
Metals, 2021 The ferrite fraction and phase distribution of duplex steels depend strongly on the temperature evolution during hot deformation and are correlated to different mechanical behaviors during hot deformation as well as cold deformation.
Angela Quadfasel +3 more
doaj +1 more source
Functional Composite Materials, 2023 Aluminium matrix composites (AMC) do combine a high lightweight potential with a wide range of specific mechanical or thermal properties, depending on their material composition or the content of reinforcement particles, respectively.
Marco Speth +2 more
doaj +1 more source
The influence of process parameters on the temperature development in the forming zone [PDF]
MATEC Web of Conferences, 2018 Cold metal forming is a fast and economical way of producing a wide range of precise components. Its profitability mainly depends on part quality, process stability and service intervals of tools.
Tröber Philipp +5 more
doaj +1 more source
On the Direct Extrusion of Solder Wire from 52In-48Sn Alloy
Machines, 2021 In this article, technology for producing wire and rod solder from 52In-48Sn alloy has been developed and investigated in the conditions of small-scale production.
Sergei Faizov +8 more
doaj +1 more source