Results 71 to 80 of about 4,711,558 (216)

AS-336-90 Resolution on Change of Department Name for Metallurgical and Materials Engineering Department [PDF]

open access: yes, 1990
Changes name of Metallurgical and Materials Engineering Department to Materials Engineering ...
Metallurgical and Materials Engineering Department,
core  

Achieving High ON State Current through Ferroelectric Polarization‐Dependent Interfacial Resistance Switching in Undoped Orthorhombic HfO2 Films

open access: yesAdvanced Functional Materials, EarlyView.
Ferroelectric tunnel junction devices based on epitaxial undoped ferroelectric HfO2 films demonstrate stable switching endurance of over 106 switching cycles, low write voltages of ±3 V, 16 measured resistance states, and neuromorphic capability.
Markus Hellenbrand   +13 more
wiley   +1 more source

Department of Metallurgical and Materials Engineering newsletter Winter 2020

open access: yes, 2020
"A Newsletter for Friends & Supporters of the Colorado School of Mines' George S.

core  

Atom Probe Tomography as an Emerging Tool for Understanding Defect‑Driven Mechanisms in HfO2‑Based Ferroelectrics

open access: yesAdvanced Functional Materials, EarlyView.
This Perspective highlights atom probe tomography as a powerful tool for understanding the atomic‐scale defect chemistry in HfO2‐based ferroelectrics. 3D mapping of dopants, point defects, and interface chemistry can provide new insight into defect‐driven mechanisms underpinning the ferroelectricity in the system and guide the design of more reliable ...
Kasper Hunnestad   +3 more
wiley   +1 more source

Tracking Battery Microstructural Degradation Through Directional Thermal Transport Signatures

open access: yesAdvanced Functional Materials, EarlyView.
In lithium‐ion batteries, heat conduction varies between the through‐plane and in‐plane directions because of the cell's layered structure. Therefore, cell degradation influences thermal conductivity in each direction uniquely due to detailed microstructural and compositional changes.
Mohammad Shoghi Tekmedash   +6 more
wiley   +1 more source

Silicon Extraction from a Diamond Wire Saw Silicon Slurry with Flotation and the Flotation Interface Behavior

open access: yesMolecules
Diamond wire saw silicon slurry (DWSSS) is a waste resource produced during the process of solar-grade silicon wafer preparation with diamond wire sawing.
Lin Zhu   +5 more
doaj   +1 more source

Department of Metallurgical and Materials Engineering newsletter Fall 2025 [PDF]

open access: yes
"A Newsletter for Friends & Supporters of the Colorado School of Mines' George S.

core  

Phase Engineering of Nanomaterials (PEN): Evolution, Current Challenges, and Future Opportunities

open access: yesAdvanced Materials, EarlyView.
This review summarizes the synthesis, phase transition, advanced characterization spanning ex situ to in situ and operando techniques, and diverse applications of phase engineering of nanomaterials (PEN). It further outlines key challenges and future opportunities, such as phase stability, architecture control, and artificial intelligence (AI)‐driven ...
Ye Chen   +7 more
wiley   +1 more source

Advanced microstructural path modeling of primary recrystallization in aluminum alloys AA5182 and AA5657

open access: yesMetalMat
When analyzing recrystallization kinetics data, it is extremely important to use a model, which has appropriate assumptions for nucleation and growth, including spatial distribution of nuclei, nucleation rate, growth rate, and directionality.
R. A. Vandermeer   +5 more
doaj   +1 more source

Review of Silicon Recovery from Diamond Wire Saw Silicon Powder Waste Based on Hydrometallurgical Process

open access: yesMolecules
The photovoltaic (PV) industry is developing rapidly to support energy transformation and emission reduction. In the whole PV industry chain, diamond wire saw silicon powder (DWSSP) waste is the most promising secondary resource for recycling high-purity
Baoshan Xiong   +5 more
doaj   +1 more source

Home - About - Disclaimer - Privacy