Results 151 to 160 of about 2,983,736 (353)
Advanced Engineering Materials, EarlyView.The thermal diffusivity of MgO‐C refractories is highly sensitive to sample preparation and processing procedures. In this article, the effects of coking sequence, machining conditions, structural inhomogeneity, and graphite coating application on measurements using laser flash apparatus are systematically investigated.
Luyao Pan +4 more
wiley +1 more source
Leaching of liquation-feeding furnace dross as a first step for germanium recovery
BMC Research NotesObjective Germanium, an important component of electronics, is considered by many global economies as a critical raw material. Therefore, investigating its potential new sources is crucial for prospective technology development.
Michał Drzazga +5 more
doaj +1 more source
Erratum: Attosecond Photoelectron Spectroscopy of Metal Surfaces [Phys. Rev. Lett.102, 123601 (2009)] [PDF]
, 2009 C.-H. Zhang, Uwe Thumm
openalex +1 more source
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
Calculation of heat transfer coefficients
Metalurgija, 2019 In forced-convection furnaces for reheating Al-alloys, convective heat transfer mechanism dominates. Al-body temperature prediction model uses measured furnace temperature as boundary condition.
F. Vode +4 more
doaj
Erratum: First-principles calculation of the structural stability of
, 2011 A. Östlin, Levente Vitos
openalex +1 more source
Advanced Engineering Materials, EarlyView.Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar +2 more
wiley +1 more source
Analysis of the initial deformabiliti of austenitic stainless stells with a bend test
Metalurgija, 2019 Austenitic stainless steel solidify under non-equilibrium conditions, and form two-phase microstructure of austenite and δ-ferrite. Workability of steels in hot are better in the primary crystallization of δ-ferrite. The influence of chemical composition
B. Arh +4 more
doaj
Advanced Engineering Materials, EarlyView.This study investigates the tribological response of 60NiTi alloy under dry, water‐lubricated and high‐temperature conditions. The alloy exhibits decreasing wear volume and friction with increasing temperature due to the formation of protective oxide layers. The work clarifies dominant wear mechanisms and demonstrates the suitability of 60NiTi for high‐
Anthony Onyebuchi Okoani +2 more
wiley +1 more source