Results 51 to 60 of about 8,140 (304)
A thermoplastic PMMA‐based photoresin enables high‐resolution DLP printing followed by solvent‐vapor smoothing. The treatment reduces staircase‐induced surface roughness from 2.33 µm to 129 nm and increases visible‐light transmittance from approximately 30% to 80%, providing a route toward transparent PMMA components for rapid prototyping and non ...
Rozhin Heydarpour +5 more
wiley +1 more source
Meta-analysis of the clinical behavior of posterior direct resin restorations: Low polymerization shrinkage resin in comparison to methacrylate composite resin. [PDF]
Polymerization shrinkage of resin composite can compromise the longevity of restorations. To minimize this problem, the monomeric composition of composites have been modified.
Paula de Castro Kruly +6 more
doaj +1 more source
A synthetic route to sulfobetaine methacrylates with varying charge distance
A general synthetic strategy is described that enables access to a library of new sulfobetaine methacrylates starting from commercially available precursors.
Leonie Barner +9 more
core +1 more source
Shellac, a centuries‐old natural resin, is reimagined as a green material for flexible electronics. When combined with silver nanowires, shellac films deliver transparency, conductivity, and stability against humidity. These results position shellac as a sustainable alternative to synthetic polymers for transparent conductors in next‐generation ...
Rahaf Nafez Hussein +4 more
wiley +1 more source
Computation of density of perfluoroalkyl methacrylates: a molecular modeling approach
Molecular dynamics simulations have been carried out on different perfluoroalkyl methacrylates to predict their densities. Density calculations on selected perfluoroalkyl methacrylates have been performed using molecular dynamics in the NPT ensemble by ...
Parthasarathi, R. +3 more
core +1 more source
In MOCVD MoS2 memristors, a current compliance‐regulated Ag filament mechanism is revealed. The filament ruptures spontaneously during volatile switching, while subsequent growth proceeds vertically through the MoS2 layers and then laterally along the van der Waals gaps during nonvolatile switching.
Yuan Fa +19 more
wiley +1 more source
pH sensitive hydrogels based on methacrylates
Novel copolymeric hydrogels based on methacrylates were prepared by chemical radical copolymerization of poly(alkylene glycol) methacrylates (BIS) and 2-hydroxyethyl methacrylate (HEMA) in a mixture of water/ethanol as solvent.
Tomić, Simonida +4 more
core +4 more sources
Respiratory effects of exposure to methacrylates among dental assistants
BACKGROUND: Case reports of occupational asthma in dental personnel have been published, but there is little data on the risk of respiratory disorders related to occupational exposure to methacrylates in dental assistants. The objective of this study was
Leino, T +5 more
core +1 more source
Integration of Low‐Voltage Nanoscale MoS2 Memristors on CMOS Microchips
This article presents the first monolithic integration of nanoscale MoS2‐based memristors into the back‐end‐of‐line of foundry‐fabricated CMOS microchips in a one‐transistor‐one‐resistor (1T1R) architecture. The MoS2‐based 1T1R cells exhibit forming‐free, nonvolatile resistive switching with ultra‐low operating voltages, low cycle‐to‐cycle variability ...
Jimin Lee +16 more
wiley +1 more source
Polarization holography in azobenzene polymeric films prepared using the new chemical method
The recording media for polarization holography based on azobenzene polymers are obtained by polymer-analogous transformations of polymethacrylic acid and its copolymers with alkyl methacrylates.
N.A. Davidenko +5 more
doaj +1 more source

