Results 141 to 150 of about 147,273 (291)
Photocatalytic degradation of methyl orange using TiO2 impregnated activated carbon [PDF]
Photocatalytic active TiO2 impregnated activated carbon TiO2/AC with various ratios were prepared by sol-gel method. Methyl orange (MO) was used as target pollutant to test the activity of the catalysts under two different light sources.
Muhammad, Abubakar
core
Growth‐Pathway‐Controlled van der Waals Epitaxy of Phase‐Selective Tin Sulfides
Growth‐pathway‐controlled van der Waals epitaxy enables deterministic phase selection and strain engineering in tin sulfide/WSe2 heterostructures. Direct growth of SnS induces substrate‐mediated strain and phase evolution, whereas sequential growth through an SnS2 buffer suppresses strain transfer and stabilizes pristine α‐SnS, revealing a versatile ...
Jaehyeok Lee +2 more
wiley +1 more source
Pengaruh Konsentrasi So42- Terhadap Degradasi Methyl Orange Menggunakan Fotokatalis Tio2-bentonit [PDF]
Penelitian ini mengkaji pengaruh anion sulfat (SO42-), lama penyinaran,dan jumlah fotokatalis terhadap degradasimethyl orange menggunakan fotokatalis TiO2-bentonit.
Wardhani, Sri +5 more
core
The incorporation of oxygen vacancies (OVs) presents a viable strategy for fine‐tuning the photocatalytic prowess of BiOCl. A reliable hydrogen annealing reduction technique is employed to precisely design OVs, thereby optimizing the light absorption capacity, as well as the efficiency of carrier migration and separation in BiOCl.
Shuaihao Ma +11 more
wiley +1 more source
Pembuatan Kitosan Makropori Menggunakan Epichlorohydrin sebagai Cross-linker dan Aplikasinya terhadap Adsorpsi Methyl Orange [PDF]
Kitosan makropori dibuat dengan menggunakan garam dapur NaCl sebagai porogen dan epichlorohydrin sebagai cross-linker. Kitosan makropori tersebut digunakan untuk adsorpsi zat warna methyl orange.
Sabarudin, A. (Akhmad) +5 more
core
Analog Weight Update Rule in Ferroelectric Hafnia, Using picoJoule Programming Pulses
Resistive, ferroelectric synaptic weights based on BEOL‐compatible hafnia/zirconia nanolaminates are fabricated. Lateral downscaling the devices below 10 µm2 enables 20 ns programming with electrical pulses, dissipating ≤ 3 pJ. Experimental results show that final conductance state is set by pulse amplitude, and is largely independent of the initial ...
Alexandre Baigol +7 more
wiley +1 more source
Pengaruh Penambahan No3- Terhadap Degradasi Methyl Orange Menggunakan Fotokatalis Tio2-bentonit [PDF]
Penelitian ini bertujuan untuk mengetahui pengaruh penambahan anion NO3-terhadap degradasi methyl orange menggunakan fotokatalis TiO2-bentonit. Larutan methyl orange 10 mg/L pH 4 sebanyak 25 mL ditambah 50 mg TiO2-bentonit dan 5 mL larutan NO3-0; 0,5; 1 ...
Darmawan, Panji Rahmat +5 more
core
Fabrication of Composite Cathode for All‐Solid‐State Sodium Batteries
The design of composite cathodes for all‐solid‐state sodium batteries must address three critical challenges—interfacial side reactions, interfacial delamination, and highly tortuous transport pathways. This work outlines structural and interfacial strategies to optimize ion transport and mechanical stability, enabling durable, and high‐performance ...
Gaoming Sun +6 more
wiley +1 more source
Ni‐rich cathodes in sulfide‐based ASSBs undergo intertwined (electro)chemical and mechanical degradation. Here, a new diagnostic framework is presented to decouple each contribution by partitioning capacity fading into charge and discharge fading.
Jangwhan Seok +12 more
wiley +1 more source
Silicon anodes in sulfide SSBs face coupled electrochemo‐mechanical failure by interface instability. This review examined recent advances and proposed mitigation strategies via material‐, electrode/interface‐, and cell‐level‐ engineering. We further evaluate scalable synthesis of sulfide SEs.
Murugesan Karuppaiah +4 more
wiley +1 more source

