Results 41 to 50 of about 35,160 (247)
We report on the magnetic properties of antiferromagnetic NiO(001) thin films in epitaxially grown NiO/MgO(d MgO )/Cr/MgO(001) system for different thicknesses of MgO, d MgO . Results of X-ray Magnetic Linear Dichroism show that together with an increase
W. Janus +12 more
doaj +1 more source
Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
To reduce carbon emissions and explore carbon dioxide (CO2) utilization technologies in geotechnical engineering, this study proposes a novel method for preparing carbon sequestration lightweight soil (C-LS) based on the magnesium oxide (MgO) carbonation
LIU Songyu1, 2 , ZHANG Xiang1, CAI Guanghua3, YUAN Zhenyang1, AN Jingfeng4, CHEN Guangwei
doaj +1 more source
This study investigates thermo‐chemical processes during high‐temperature testing of two commercial MgO‐C brick grades, one containing 47.5 wt.% MgO‐C recyclate. Using ETV, DTA/TG‐MS, XRD, and SEM/EDS/EBSD, mechanisms such as carbothermal reduction of magnesia, impurity incorporation into the secondary MgO surface layer, and calcium‐rich phase ...
Alexander Schramm +6 more
wiley +1 more source
Full-potential KKR calculations for MgO and divalent impurities in MgO [PDF]
We present a detailed investigation of bulk properties of MgO and lattice relaxations around divalent impurities in MgO by means of the full-potential Korringa-Kohn-Rostoker Green's function method. The local-density approximation and the perturbative generalized gradient corrections are used to calculate the lattice constant and bulk modulus of MgO ...
Baranov, A. N. +6 more
openaire +2 more sources
Carbon‐free inert anodes are essential for decarbonizing aluminum electrolysis. This study investigates a recyclate‐based MgO‐316L steel composite anode tested under galvanostatic Hall–Héroult conditions in cryolite at 1000°C. Microstructural analysis reveals selective MgO fluorination, spinel and oxide layer formation, electrolyte infiltration, and ...
Serhii Yaroshevskyi +7 more
wiley +1 more source
The present work describes the preparation of MgO nanoparticles (MgO/NPs) by co-precipitation method using CTAB/MgO nanoparticles (CTAB/MgO/NPs) and TX-100/MgO nanoparticles (TX-100/MgO/NPs) surfactant.
K.G. Manjunatha +4 more
doaj +1 more source
The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert +6 more
wiley +1 more source
Position of Fe ions in MgO crystalline structure
Magnesium oxide (MgO) is one of the most important raw materials in many branches of industry. Magnesium oxide is a popular refractory raw material because of its high refractoriness and high resistance to basic slags and environment.
Szczerba Jacek +4 more
doaj +1 more source
EDX elemental map of the pre‐oxidized MgO–steel cermet anode cross section after electrolysis. The development of inert anodes for aluminum electrolysis remains challenging due to the high corrosivity of cryolite‐based melts at 950°C–1000°C. This study investigates the corrosion and process behavior of a carbon‐free MgO–steel cermet anode derived from ...
Alexander Adamczyk +7 more
wiley +1 more source

