Results 21 to 30 of about 2,749 (232)
Sensitivity and Performances Analysis of a Dynamic Pressure Narrow-Band Electrodynamic Micro- Sensor
This paper presents analytic and numerical modelling of a MEMS electrodynamic micro-sensor of dynamic pres- sure. Two coaxial planar inductors of different diameters are used in the proposed micro-sensor design.
Tounsi, Fares +4 more
core +1 more source
Graphene nanoplatelet (0.1 wt.%) reinforcement significantly enhances the performance of β Ti‐28Nb‐35.4Zr alloy. Grain refinement, reduced water contact angle, and improved surface characteristics promote osteoblast adhesion and complete surface coverage after 7 days.
Khurram Munir +5 more
wiley +1 more source
Simulation and Optimization Design of Inductive Wear Particle Sensor
In order to monitor the diagnosis of mechanical equipment by monitoring the metal wear particles carried in large aperture lubricating oil tubes, the simulation optimization structure design was carried out based on the traditional three-coil inductance ...
Song Feng +4 more
core +1 more source
Natural Biomaterials for Osteochondral Repair: From Source to Strategy
Biological origin‐guided overview of natural biomaterials and therapeutic strategies for osteochondral tissue engineering. The circular diagram categorizes representative materials and strategies into plant/algae‐derived, microbial‐derived, animal‐derived, and human‐derived sources, centered on an osteochondral defect repair model.
Hengyu Liu +5 more
wiley +1 more source
Magnetic flux guidance using H structures for miniature transducers [PDF]
Limited magnetic flux has been a significant restriction in the applicability of scaled-down inductive energy, sensing and actuating devices. Magnetic flux concentration could potentially address this challenge by offering higher flux density B and ...
Kiziroglou, Michail E +5 more
core +1 more source
Leaftronics: Bio‐Fractal Scaffolds From Leaf Venation for Low‐Waste Electronics
“Leaftronics” transforms naturally evolved leaf venation into quasi‐fractal scaffolds for sustainable electronics. Polymer‐infiltrated leaf skeletons can be used to fabricate ultra‐smooth, reflow‐ and thin‐film‐compatible decomposable substrates, while making the same lignocellulose networks conducting results in flexible transparent electrodes.
Rakesh Rajendran Nair +3 more
wiley +1 more source
The development of a multi-frequency electromagnetic instrument for monitoring the phase transformation of hot strip steel. [PDF]
This paper describes the development of an instrument to analyze the phase transformations of hot strip steel using an electromagnetic sensor. The sensor exploits variations in the electrical conductivity and magnetic permeability of the steel to monitor
Binns, R +9 more
core
An orbital‐hybridizable nanoseed (OHNS) interphase induces strong orbital hybridization between Zn and carbon edges, accelerating Zn nucleation while suppressing 2D surface diffusion. This interfacial electronic regulation drives uniform, dense, and (002)‐oriented Zn growth, enabling stable and fast charging behavior in anode‐free aqueous Zn batteries.
Won‐Yeong Kim +16 more
wiley +1 more source
Enhanced piezoelectric energy harvesting powered wireless sensor nodes using passive interfaces and power management approach [PDF]
Low-frequency vibrations typically occur in many practical structures and systems when in use, for example, in aerospaces and industrial machines. Piezoelectric materials feature compactness, lightweight, high integration potential, and permit to ...
Giuliano, Alessandro
core
A soft–hard tri‐layer composite electrolyte that couples fast Li+ transport with reinforced interfacial stability to enable high‐conductivity, mechanically robust, dendrite‐free lithium‐metal batteries. ABSTRACT The development of solid polymer electrolytes is central to safe, high‐energy lithium‐metal batteries (LMBs); however, persistent challenges ...
Fazal Ur Rehman +9 more
wiley +1 more source

