Results 61 to 70 of about 5,664 (208)
Наука. Инновации. Технологии, 2022 The construction of a heat exchange element based on a matrix of silicon whiskers for thermal stabilization systems of miniature heat sources with specific power up to 100 W / cm2 operating over a wide range of ambient temperatures is proposed.
Dmitry Albertovich Konovalov
doaj
Probabilistic Flow Regime Map Modeling of Two-Phase Flow [PDF]
, 2006 The purpose of this investigation is to develop models for two-phase heat transfer, void fraction, and pressure drop, three key design parameters, in single, smooth, horizontal tubes using a common probabilistic two-phase flow regime basis ...
Chato, J.C., Jassim, E.W., Newell, T.A.
core
Thermal and hydrodynamic studies for micro-channel cooling for large area silicon sensors in high energy physics experiments [PDF]
, 2016 Micro-channel cooling initially aiming at small-sized high-power integrated circuits is being transferred to the field of high energy physics. Today`s prospects of micro-fabricating silicon opens a door to a more direct cooling of detector modules.
Ariza, Dario +10 more
core +2 more sources
Zhileng xuebao, 2014 The wet performance of microchannel heat exchanger (Fin Pitch=1.1mm) with hydrophobic, hydrophilic and without surface coating were studied under different conditions experimentally.
Liu Luming +6 more
doaj
Performance analysis of non-circular microchannels flooded with CuO-water nanofluid [PDF]
, 2011 This paper was presented at the 3rd Micro and Nano Flows Conference (MNF2011), which was held at the Makedonia Palace Hotel, Thessaloniki in Greece.
3rd Micro and Nano Flows Conference (MNF2011) +3 more
core
Feasibility Study of the Ø5 Tube-and-fin Heat Exchanger in Automotive Heat Pump System
Zhileng xuebao, 2013 The parallel flow microchannel (PFM) heat exchanger is widely used in automotive air conditioning system, but it has the disadvantage of easy-frost and difficult in water-drain in defrost .
Wei Wei +4 more
doaj
Design and optimization of a micro heat sink for concentrating photovoltaic/thermal (CPVT) systems [PDF]
, 2011 This paper was presented at the 3rd Micro and Nano Flows Conference (MNF2011), which was held at the Makedonia Palace Hotel, Thessaloniki in Greece.
3rd Micro and Nano Flows Conference (MNF2011) +4 more
core
Experimental investigation of fluid flow and heat transfer in a single-phase liquid flow micro-heat exchanger [PDF]
, 2009 This work presents an experimental analysis of the hydrodynamic and thermal performance of micro heat exchangers. Two micro heat exchangers, characterized by microchannels of 100x100 and 200x200 µm square cross sections, were designed for that purpose ...
Acosta Iborra, Antonio +3 more
core +2 more sources
Zhileng xuebao, 2015 The microchannel heat exchanger was used as the evaporator of a separated type heat pipe, and the working fluid filling rate of the separate type heat pipe was studied experimentally when the filling rate changed from 80% to 150%.
Hu Zhangbao +4 more
doaj
Microstructure devices for process intensification: Influence of manufacturing tolerances and measurement uncertainties [PDF]
, 2011 This paper was presented at the 3rd Micro and Nano Flows Conference (MNF2011), which was held at the Makedonia Palace Hotel, Thessaloniki in Greece.
3rd Micro and Nano Flows Conference (MNF2011) +1 more
core