Results 221 to 230 of about 31,166 (292)
Some of the next articles are maybe not open access.

A 3D printed synergistic aerogel microreactor toward stable and high-efficiency photocatalytic degradation

Materials Today Chemistry, 2021
Photocatalysis offers a credible and prompt approach to solving the growing problems of environmental pollution and energy shortages. However, the practical application of photocatalytic materials still faces the challenge of the efficient catalytic ...
Yu Wang   +4 more
semanticscholar   +1 more source

Comparison of aqueous and non-aqueous alkanolamines solutions for carbon dioxide desorption in a microreactor

Energy, 2020
An experimental study of CO2 desorption from aqueous and non-aqueous saturated alkanolamine solutions carried out in a tubular microreactor, consisting of a stainless steel microtube with an internal diameter of 800 μm and a total length of 35 cm.
B. Aghel, Sasan Sahraie, E. Heidaryan
semanticscholar   +1 more source

Efficient Ni2Co4P3 Nanowires Catalysts Enhance Ultrahigh‐Loading Lithium–Sulfur Conversion in a Microreactor‐Like Battery

Advanced Functional Materials, 2019
High‐loading lithium–sulfur (Li–S) batteries suffer from poor electrochemical properties. Electrocatalysts can accelerate polysulfides conversion and suppress their migration to improve battery cyclability.
Zihan Shen   +10 more
semanticscholar   +1 more source

A thermally autonomous methanol steam reforming microreactor with porous copper foam as catalyst support for hydrogen production

, 2020
Methanol steam reforming microreactors can be used for hydrogen production in industry applications. This paper presents a novel thermally autonomous methanol steam reforming microreactor that uses porous copper foam as catalyst support to enhance the ...
Yan-cheng Wang, Ziyue Hong, Deqing Mei
semanticscholar   +1 more source

Novel copper foam with ordered hole arrays as catalyst support for methanol steam reforming microreactor

Applied Energy, 2019
Methanol steam reforming microreactor is regarded as one of the effective approaches for online hydrogen source for fuel cells and the catalyst support is one of the most important component of microreactors.
Wei Zhou, Zheng Tianqing, Shaolong Wan
exaly   +2 more sources

Hydrogen production in microreactor using porous SiC ceramic with a pore-in-pore hierarchical structure as catalyst support

, 2020
Porous SiC ceramic as catalyst support with porous CuO/ZnO/CeO2/ZrO2 catalyst was fabricated via solution combustion method and used in a microreactor. A pore-in-pore hierarchical structure was formed on the support by using glycol as the fuel.
Moyu Liao   +6 more
semanticscholar   +1 more source

Accelerating Electrochemical Reactions in a Voltage-Controlled Interfacial Microreactor.

Angewandte Chemie, 2020
Microdroplet chemistry is attracting increasing attention for accelerated reactions at the air/solution interface. We report here a novel voltage-controlled interfacial microreactor allowing acceleration of electrochemical reactions which are not ...
Heyong Cheng   +4 more
semanticscholar   +1 more source

Ultrafiltration membrane microreactor (MMR) for simultaneous removal of nitrate and phosphate from water

Chemical Engineering Journal, 2019
Removing low-concentration nitrate and phosphate from water is desirable because they may cause eutrophication when discharged, but it is challenging using current technologies.
Q. Gao   +5 more
semanticscholar   +1 more source

Photocatalytic Reduction in Microreactors

Chemistry Letters, 2006
Abstract Photocatalytic reduction of benzaldehyde and nitrotoluene in microspace was investigated by using a microreactor with immobilized titanium dioxide. Advantages of a photocatalytic microreaction system which has a remarkably large surface-to-volume ratio have been examined.
Y. Matsushita   +4 more
openaire   +1 more source

Pile-up glass microreactor

Lab on a Chip, 2002
We made a 'pile-up' microreactor in which ten levels of microchannel circuits were integrated to form a single glass entity. Solutions were distributed to each layer via cylindrical holes with a diameter much larger than that of the microchannel. Fabrication of the pile-up reactor was completed using only conventional photolithography, wet etching and ...
Yoshikuni, Kikutani   +5 more
openaire   +2 more sources

Home - About - Disclaimer - Privacy