Results 51 to 60 of about 453,146 (211)
In this paper, the feasibility of using the half-mode/quarter-mode of a substrate integrated waveguide (HMSIW/QMSIW) cavity to feed microstrip patch antennas (MPAs) is explored; based on this, a circularly polarized (CP) MPA fed by the sequential ...
Kai Sun +4 more
doaj +1 more source
Autonomous Charging and Battery Swapping for Unmanned Aerial Vehicles: A Review
This review evaluates major autonomous charging and battery swapping methods for unmanned aerial vehicles (UAVs) against a single question: how close each is to sustained unattended operation. Rather than ranking them by charging performance, it identifies the limitation that most restricts each method, and briefly outlines the supporting technologies ...
Zelin Wu +5 more
wiley +1 more source
Beam scanning using microstrip line on biased ferrite [PDF]
The beam scanning properties of a 2-element patch array fed by a microstrip reed situated on a ferrite substrate are presented. Biasing the ferrite changes the phase length or the microstrip line, scanning the beam by up to 40 degrees. The resulting scan
Langley, Richard J., Batchelor, John C.
core +1 more source
A Scalable Platform for Massively Parallel Superconducting Single‐Photon Detection
One hundred independent superconducting nanowire detectors, each with efficiency up to 80.1–98.3%, are integrated into a single compact system operating below 2.1 K. This parallel architecture supports fully connected multi‐user quantum entanglement distribution, while its scalability opens new avenues in optical quantum computing, QKD networks ...
You Xiao +14 more
wiley +1 more source
Design and analysis of quasi‐lumped notch filter with extended upper pass band
This paper presents a hybrid technique‐based compact narrow band stop filter design for broadband applications. It provides the rejection of 60 dB at the centre frequency of 2.25 GHz without any stop band harmonics over the required frequency band of ...
Mohit +3 more
doaj +1 more source
ABSTRACT Purpose The design of radiofrequency (RF) coils tailored for the target anatomy is necessary to overcome the transmit field homogeneity and penetration issues at Ultra‐High‐Field (UHF). For the spinal cord, the optimal design has not yet been determined. This work intends to demonstrate the added value of a pair of passive dipoles placed under
Hugo Amat +10 more
wiley +1 more source
Bamboo‐Slip‐Inspired Conformal Reconfigurable Metasurfaces
Bamboo‐slip‐inspired conformal reconfigurable metasurface system. The structure is mainly composed of three parts, which are conformal metasurface, pattern reconfigurable antenna, and control components (such as Field Programmable Gate Array (FPGA)). Conformal metasurfaces draw inspiration from the design of ancient Chinese bamboo slips.
Qifan Li +9 more
wiley +1 more source
A compact and sensitive spurline-based microwave sensor for non-invasive glucose detection
Non-invasive blood glucose monitoring remains a critical need in diabetes management, prompting the development of compact, sensitive, and user-friendly sensing technologies.
Ibrahim Zewail +3 more
doaj +1 more source
Textile Metamaterials: Design, Fabrication, and Emerging Applications
Textile metamaterials combine sub‐wavelength electromagnetic structures with textile architectures, enabling flexible and wearable platforms for wave manipulation. This review highlights their evolution, fabrication strategies, electromagnetic characteristics, and emerging applications, while identifying key challenges and opportunities for next ...
Samanta M. de Holanda +8 more
wiley +1 more source
An UWB LNA Design with PSO Using Support Vector Microstrip Line Model
A rigorous and novel design procedure is constituted for an ultra-wideband (UWB) low noise amplifier (LNA) by exploiting the 3D electromagnetic simulator based support vector regression machine (SVRM) microstrip line model.
Salih Demirel +2 more
doaj +1 more source

