Results 1 to 10 of about 11,803 (208)
Presently, it is difficult to measure the characteristic impedance of embroidered microstrip line for its conductive anisotropy directly. The published work had proposed to use S-parameters to estimate the port impedance of a balanced dipole antenna, and
Yaya Zhang +8 more
doaj +3 more sources
Analysis of Microstrip Line Fed Patch Antenna for Wireless Communications
In this paper, theoretical analysis of microstrip line fed rectangular patch antenna loaded with parasitic element and split-ring resonator is presented.
Singh Ashish +3 more
doaj +3 more sources
A broadband and low cross polarization antenna with a balun of microstrip line coupling to slot line. [PDF]
In this paper, a wide-band low cross polarization antenna with a structure of microstrip line coupling to slot line as the balun is proposed. The radiation part of the antenna is fed by two pairs of parallel transmission line via a transition from a slot
Kai Sun +3 more
doaj +2 more sources
Simple Modal Filter Based on Microstrip Line
Indira Y. Sagiyeva, Talgat R. Gazizov
doaj +2 more sources
Teknologi seluler Fifth Generation (5G) merupakan lompatan besar dalam kecepatan untuk perangkat nirkabel karena memberikan kecepatan data sebesar 10 hingga 100 kali lebih cepat dari jaringan 4G. Walaupun begitu terdapat suatu kendala dalam komunikasi 5G
Wahju Adi Prijono, Dimas Brahmantyo
doaj +1 more source
Transverse Resonance Technique for Analysis of Symmetrical Stub in Microstrip Transmission Line
Open or short-circuit stubs in a strip (microstrip) transmission line are one of the most common elements of planar circuits used in numerous devices in the microwave frequency range: various types of filters, couplers, power amplifiers, antennas ...
Yu. V. Rassokhina, V. G. Krizhanovski
doaj +1 more source
An Application of the Subwavelength Periodic Microstrip Guard Trace in High-Speed Circuits
This paper proposed a kind of guard traces based on a subwavelength periodic structure to reduce the far-end crosstalk (FEXT) of parallel microstrip lines in the PCB.
Chia Ho Wu +9 more
doaj +1 more source
Low-Noise Voltage Controlled Oscillator with Coupled Microstrip Lines of Different Lengths
Introduction. Coupled two- or three-wire microstrip lines are often used to reduce a phase noise of voltage-controlled oscillators (VCOs). Unfortunately, the phase noise was not optimized depending on the lengths of a three-wire coupled microstrip lines ...
Aleksander V. Baranov
doaj +1 more source
A Gain-Enhanced Patch Antenna With a Periodic Microstrip Rampart Line
In this paper, a gain-enhanced patch antenna with a periodic microstrip rampart line is proposed. The periodic microstrip rampart line can modify the effective dielectric constant of the dielectric plate, and help to improve the gain of the traditional ...
Xiaoning Chen +5 more
doaj +1 more source
A millimeter-wave band microstrip-to-coaxial transition structure
Microstrip line and coaxial are the two common transmission lines in microwave systems. The common interconnection method between the two transmission lines at the low frequency band is direct soldering.
Wang Jian +3 more
doaj +1 more source

