Results 21 to 30 of about 334,526 (272)
IEEE Photonics Journal, 2022 This paper presents a photonics-based instantaneous microwave frequency measurement system. The system operates based on the frequency-to-power mapping technique.
Henghao Chen +2 more
doaj +1 more source
Microwave Measurements Part II Non-linear Measurements [PDF]
IEEE Instrumentation & Measurement Magazine, 2007 This paper addresses the problems in microwave non-linear measurements. It discusses techniques to synthesize loads, the most used non-linear measurement techniques, and harmonic load-pulling. An experimental setup for characterizing power amplifiers must be able to measure the complex spectrum of the waves at the amplifier ports as a function of ...
CAMARCHIA, VITTORIO +3 more
openaire +1 more source
Optical Fiber Displacement Sensor Based on Microwave Photonics Interferometry
Sensors, 2018 An optical fiber displacement sensor based on the microwave photonics interferometric (MWPI) method is proposed and experimented, which provides an ideal solution for large range displacement measurement with high resolution.
Hao Dong +4 more
doaj +1 more source
Signatures of Hong-Ou-Mandel Interference at Microwave Frequencies [PDF]
, 2013 Two-photon quantum interference at a beam splitter, commonly known as Hong-Ou-Mandel interference, was recently demonstrated with \emph{microwave-frequency} photons by Lang \emph{et al.}\,\cite{lang:microwaveHOM}.
Blais, A. +4 more
core +1 more source
Microwave-assisted and conventional hydrothermal carbonization of lignocellulosic waste material: comparison of the chemical and structural properties of the hydrochars [PDF]
, 2015 This study compares the chemical and structural properties of the hydrochars prepared from microwave-assisted and conventional hydrothermal carbonizations of Prosopis africana shell, a waste plant material.
Elaigwu, Sunday E., Greenway, Gillian M.
core +1 more source
IEEE Photonics Journal, 2017 We propose and experimentally demonstrate photonic measurement of microwave frequency by utilizing an optomechanical microring resonator (MRR). The pump powers injected into the MRR would result the resonance red-shifts based on nonlinear effects. In the
Li Liu, Huaqing Qiu, Zhi Chen, Zhihua Yu
doaj +1 more source
Development of a Solid and Flexible Matching Medium for Microwave Medical Diagnostic Systems
Diagnostics, 2021 This paper reports the development of a new composite material as a matching medium for medical microwave diagnostic systems, where maximizing the microwave energy that penetrates the interrogated tissue is critical for improving the quality of the ...
Amin Moradpour +5 more
doaj +1 more source
Precise measurement of complex permittivity of materials for telecommunications devices
Journal of Telecommunications and Information Technology, 2001 In order to obtain precise complex permittivity of the dielectric materials obtained from the perturbation method a correction curve is made using the electromagnetic field simulator which applies transmission line modeling (TLM) method.
Takayuki Nakamura, Yoshio Nikawa
doaj +1 more source
Planar Superconducting Resonators with Internal Quality Factors above One Million
, 2012 We describe the fabrication and measurement of microwave coplanar waveguide resonators with internal quality factors above 10 million at high microwave powers and over 1 million at low powers, with the best low power results approaching 2 million ...
Barends, R. +18 more
core +1 more source
Heating causes non-linear microwave absorption anomaly in single wall carbon nanotubes [PDF]
, 2018 Microwave impedance measurements indicate a non-linear absorption anomaly in single wall carbon nanotubes at low temperatures (below $20$ K). We investigate the nature of the anomaly using a time resolved microwave impedance measurement technique.
Csősz, Gábor +6 more
core +2 more sources