Results 161 to 170 of about 465,829 (214)

Study on Novel Rectifiers for Microwave Wireless Power Transfer System

open access: yesStudy on Novel Rectifiers for Microwave Wireless Power Transfer System
openaire   +1 more source

Low cost and efficient rectifier design for microwave energy harvesting

open access: yes2013 Loughborough Antennas & Propagation Conference (LAPC), 2013
In this article we present a low cost and efficient rectenna design at 2.485 GHz for microwave energy transfer. The antenna and the rectifying circuitry are designed and printed on a FR4 substrate. A single stage voltage doubler rectifier with harmonic terminations is studied and developed for conversion efficiency optimization. Experimental results of
Mabrouki, Aya   +2 more
openaire   +3 more sources

High-Efficiency Microwave Rectifier With Extended Operating Bandwidth

IEEE Transactions on Circuits and Systems II: Express Briefs, 2018
This brief presents a microwave rectifier using a novel impedance matching technique to extend the operating bandwidth. Originated from the impedance control at two separated frequencies, the matching network is capable of manipulating the impedance over a wide frequency band by three steps. In this way, the operating bandwidth is extended. Theoretical
Zhi-Xia Du, Xiu Yin Zhang, Yue Long Lin
exaly   +3 more sources

Power Combining in an Array of Microwave Power Rectifiers

IEEE Transactions on Microwave Theory and Techniques, 1979
To obtain useful power levels for proposed freespace microwave power transmission applications, numerous rectifier outputs are interconnected in series and/ or parallel to share a common DC load. This work analyzes the resultant efficiency degradation when identical rectifiers operate at different RF power levels as caused by the power beam taper.
J M Borrego, R J Gutmann
exaly   +2 more sources

Microwave Transistor Power Rectifiers and Applications

2016 IEEE Compound Semiconductor Integrated Circuit Symposium (CSICS), 2016
This paper presents design, analysis and experimental results on synchronous and self- synchronous microwave transistor rectifiers implemented with GaN HEMTs at frequencies from 2 to 10GHz. The rectifier/power amplifier duality is explained and measurements confirming this mode of operation are presented.
Tibault Reveyrand, Zorana B. Popovic
exaly   +2 more sources

Study of a Matching Circuit Effect on a Microwave Rectifier

2011 11th Mediterranean Microwave Symposium (MMS), 2011
An effective method is proposed to design a matching circuit for a microwave rectifier in order to manage the frequency bandwidth and the power bandwidth. Although the input impedance is affected by the nonlinear behavior of diodes with the variation of input power levels, the analysis on a variety of matching circuit configuration brings more evidence
Zhou, Yuwei   +2 more
exaly   +3 more sources

Study on a Microwave Rectifier With Intermittent Input Signal

2017 IEEE Wireless Power Transfer Conference (WPTC), 2017
For the practical realization of Microwave power transfer (MPT), high-efficiency rectifiers are required. In this paper, we studied on the rectifiers with intermittent input signal. Intermittent signal has high peak-to-average power ratio. Therefore, there exists the possibility of boosting the RF-DC conversion efficiency.
Naoki Shinohara, Takashi Hirakawa
exaly   +2 more sources

Efficient Microwave Rectifier With Minimized Size

2022 IEEE MTT-S International Wireless Symposium (IWS), 2022
In this paper, an efficient and minimized rectifier using lumped inductors and capacitors is introduced. To simplify the design, an inductor is used to cancel the imaginary part of the Schottky diode for the input matching circuit design. Then, a LC lowpass filter is designed to suppress the RF signal at the DC output port.
Cheng, Fei, Gu, Chao
openaire   +2 more sources

A Dual-Frequency Microwave Rectifier Circuit for Microwave Power Transmission

2021 IEEE MTT-S International Wireless Symposium (IWS), 2021
In this paper, a dual-frequency rectifier circuit with high conversion efficiency is proposed for microwave power transmission (MPT). The Class-F load structure is adopted in the harmonic suppression network. In order to determine the input power and load resistance, the impedance matching network is optimized by source-pull simulation.
Haoran Qu   +10 more
openaire   +1 more source

Investigation of Rectifier Circuit Configurations for Microwave Power Transmission System Operating at S Band [PDF]

open access: yesInternational Journal of Electrical and Computer Engineering, 2015
The purpose of this work is to propose rectifier circuit topologies for microwave power transmission system operating at ISM band. This paper particularly presents in detail the proposed rectifier circuit configurations including series diode half wave ...
Bach, Duong Gia   +3 more
exaly   +2 more sources

Home - About - Disclaimer - Privacy