Results 61 to 70 of about 356,037 (289)
Advanced Engineering Materials, EarlyView.This study investigates the tribological response of 60NiTi alloy under dry, water‐lubricated and high‐temperature conditions. The alloy exhibits decreasing wear volume and friction with increasing temperature due to the formation of protective oxide layers. The work clarifies dominant wear mechanisms and demonstrates the suitability of 60NiTi for high‐
Anthony Onyebuchi Okoani +2 more
wiley +1 more source
Metals, 2017 Waste-concrete recycling processes using wet-based crushing methods inevitably generate a large amount of alkaline concrete sludge, as well as wastewater, which contains abundant Ca ions. The Ca-rich alkaline wastewater must then be neutralized for reuse
Jongchan Yoo, Heeyoung Shin, Sangwoo Ji
doaj +1 more source
Meeting report: a hard look at the state of enamel research. [PDF]
, 2017 The Encouraging Novel Amelogenesis Models and Ex vivo cell Lines (ENAMEL) Development workshop was held on 23 June 2017 at the Bethesda headquarters of the National Institute of Dental and Craniofacial Research (NIDCR).
Bartlett, John D +13 more
core +1 more source
Electrical Conductivities of Conductors, Semiconductors, and Their Mixtures at Elevated Temperatures
Advanced Engineering Materials, EarlyView.This article presents a comprehensive review of temperature‐dependent electrical conductivity data for multiple material classes at elevated temperatures, highlighting a persistent conductivity gap between metals and semiconductors in the range of 102$\left(10\right)^{2}$– 107$\left(10\right)^{7}$ S/m. Metal–ceramic irregular metamaterials are proposed
Valentina Torres Nieto, Marcia A. Cooper
wiley +1 more source
A Late Triassic gravity flow depositional system in the southern Ordos Basin
Petroleum Exploration and Development, 2014 Based on the analysis of numerous drill cores and drilling data, lacustrine gravity flow depositional systems were analyzed comprehensively in the Chang6 and Chang7 oil members (Triassic Yanchang Formation) in the southern part of the Ordos Basin.
Renchao YANG +5 more
doaj +1 more source
Frontiers in Earth Science, 2021 In this paper, the variation of clay minerals and their influence on reservoir physical properties and residual oil before and after ASP flooding are analyzed.
Liang Yingjie +4 more
doaj +1 more source
Simulating microbial degradation of organic matter in a simple porous system using the 3-D diffusion-based model MOSAIC [PDF]
, 2013 This paper deals with the simulation of microbial degradation of organic matter in soil within the pore space at a microscopic scale. Pore space was analysed with micro-computed tomography and described using a sphere network coming from a geometrical ...
Chenu, Claire +6 more
core +8 more sources
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Metals, 2018 In this study, the possibility of using concrete-sludge recycling as an immobilizer, including dried sludge (DS), precipitated calcium carbonate (PCC), and calcite-coated particles (CCP), was evaluated for the remediation of Cu-, Pb-, and Zn-contaminated
Jongchan Yoo, Heeyoung Shin, Sangwoo Ji
doaj +1 more source
Advanced Engineering Materials, EarlyView.This study investigates thermo‐chemical processes during high‐temperature testing of two commercial MgO‐C brick grades, one containing 47.5 wt.% MgO‐C recyclate. Using ETV, DTA/TG‐MS, XRD, and SEM/EDS/EBSD, mechanisms such as carbothermal reduction of magnesia, impurity incorporation into the secondary MgO surface layer, and calcium‐rich phase ...
Alexander Schramm +6 more
wiley +1 more source