Flow boiling heat transfer of refrigerant R-134a in copper microchannel heat sink [PDF]
, 2014 This paper was presented at the 4th Micro and Nano Flows Conference (MNF2014), which was held at University College, London, UK. The conference was organised by Brunel University and supported by the Italian Union of Thermofluiddynamics, IPEM, the ...
4th Micro and Nano Flows Conference (MNF2014) +2 more
core
Numerical analysis of the 3D flow induced by propagation of plane-wave deformations on thin membranes inside microchannels [PDF]
, 2007 Propulsion mechanisms of microorganisms are based on either beating or screw-like motion of thin elastic biopolymers. Arguably, this motion is optimal for propulsion at very low Reynolds numbers. Similar actuation mechanisms can be utilized in the design
Tabak, Ahmet Fatih +2 more
core +1 more source
Investigation of Two-Phase Flow in Short Horizontal Mini Channel Height of 1 MM
MATEC Web of Conferences, 2016 The experiments with two-phase flow in the short horizontal rectangular minichannel with the height of 1 mm and width of 29 mm have been carried out using water and gas nitrogen.
Ron’shin Fedor, Cheverda Vyacheslav
doaj +1 more source
An experimental investigation of structured roughness on heat transfer during single-phase liquid flow at microscale [PDF]
, 2011 This paper was presented at the 3rd Micro and Nano Flows Conference (MNF2011), which was held at the Makedonia Palace Hotel, Thessaloniki in Greece.
3rd Micro and Nano Flows Conference (MNF2011) +2 more
core
Transition regime analytical solution to gas mass flow rate in a rectangular micro channel [PDF]
, 2012 We present an analytical model predicting the experimentally observed gas mass flow rate in rectangular micro channels over slip and transition regimes without the use of any fitting parameter.
Dadzie, Kokou, Dongari, Nishanth
core +3 more sources
E3S Web of Conferences, 2018 This article presents the results of experimental research of heat transfer coefficient in air cooled vertical pipe minichannels during R404A, R407C and R410A high-pressure refrigerants condensation.
Bohdal Tadeusz +3 more
doaj +1 more source
An extension to the Navier-Stokes-Fourier equations by considering molecular collisions with boundaries [PDF]
, 2008 In this paper we propose a model for micro gas flows consisting of the Navier-Stokes-Fourier equations (NSF) extended by a description of molecular collisions with solid boundaries and discontinuous velocity slip and temperature jump boundary conditions.
Arlemark, E.J. +2 more
core
Single-pulse dynamics and flow rates of inertial micropumps
, 2016 Bubble-driven inertial pumps are a novel method of moving liquids through microchannels. We combine high-speed imaging, computational fluid dynamics (CFD) simulations and an effective one-dimensional model to study the fundamentals of inertial pumping ...
Govyadinov, A. N. +3 more
core +1 more source
EnergiesThis study focuses on the phenomenon of boiling heat transfer during fluid flow (Fluorinert FC-72) in minichannels. The research stand was built around a specially designed test section incorporating sets of aligned minichannels, each 1 mm deep.
Beata Maciejewska +2 more
doaj +1 more source
Experimental design with integrated temperature sensors in MEMS: an example of application for rarefied gases [PDF]
, 2011 This paper was presented at the 3rd Micro and Nano Flows Conference (MNF2011), which was held at the Makedonia Palace Hotel, Thessaloniki in Greece.
3rd Micro and Nano Flows Conference (MNF2011) +3 more
core