Results 101 to 110 of about 6,607 (254)

A novel bubbling fluid bed reactor for the autothermal pyrolysis of waste plastics

The Canadian Journal of Chemical Engineering, EarlyView.
Abstract A new pilot‐scale fluidized bed reactor operated under continuous conditions was developed and tested for the thermal pyrolysis of high‐density polyethylene (HDPE). The study focused on assessing the reliability and operability of the system under different operating conditions (400–550°C), while monitoring mass and energy balances, product ...
Khadija Olivia Ogoula Igouwe, Tchini Sévérin Tanoh, Jasmin Blanchard, Inès Esma Achouri, Nicolas Abatzoglou   +4 more
wiley   +1 more source

Experimental Research on the Ignition Characteristics and Inhibition Strategy for Venting Emissions Mixture of Failure LiFePO₄ Battery

Batteries
When the concentration of a gas is below its lower flammable limit and the content of a liquid is below its minimum explosible concentration, their combined fuel mixture can be ignitable.
Yan Wang, Zhaozhi Zhang, Ruiguang Yu, Yalun Li, Hewu Wang, Languang Lu, Xuning Feng, Minggao Ouyang   +7 more
doaj   +1 more source

Prediction of Minimum Spontaneous Ignition Temperature(MSIT) of the Mixture of n-Pentanol and Ethylbenzene

Journal of the Korean Institute of Gas, 2012
The MSITs(Minimum Spontaneous Ignition Temperatures) or AITs(Autoignition Temperatures) describe the minimum temperature to which a substance must be heated, without the application of a flame or spark, which will cause that substance to ignite. This study measured the MSITs(Minimum Spontaneous Ignition Temperatures) of n-pentanol+ethylbenzene system ...
openaire   +2 more sources

A perspective on parsimonious hybrid models for online use: Augmenting fundamental models with ARIMA disturbances

The Canadian Journal of Chemical Engineering, EarlyView.
Abstract Hybrid models (HMs) combine fundamental model (FM) equations with empirical components. These models can lead to improved predictions because they reduce process/model mismatch and can account for phenomena that are not considered in the FM equations.
Mouna Y. Harb, Kimberley B. McAuley
wiley   +1 more source

Evidence of Free‐Bound Transitions in Warm Dense Matter and Their Impact on Equation‐of‐State Measurements

Contributions to Plasma Physics, EarlyView.
ABSTRACT Warm dense matter (WDM) is now routinely created and probed in laboratories around the world, providing unprecedented insights into conditions achieved in stellar atmospheres, planetary interiors, and inertial confinement fusion experiments.
M. P. Böhme, L. B. Fletcher, A. D. Baczewski, H. M. Bellenbaum, Z. A. Moldabekov, J. Vorberger, D. A. Chapman, M. J. MacDonald, S. Schwalbe, T. R. Preston, D. Kraus, T. Gawne, F. R. Graziani, S. Hamel, T. Döppner, T. Dornheim   +15 more
wiley   +1 more source

Experimental study on burning rate and flame geometry in construction tunnel fires under high geothermal conditions

Deep Underground Science and Engineering, EarlyView.
Abstract As tunnel construction advances in lengths and depths, the construction of tunnels in high geothermal environments has become increasingly common, raising significant fire risks. In this study, a 1:20 scale model tunnel test platform was constructed to investigate the effects of a high geothermal environment on fire behavior in tunnels during ...
Xiaoxian Fei, Maozhen Liu, Jiayi Ha, Linbo Du, Zhi Li, Yuhao Li, Chuangang Fan   +6 more
wiley   +1 more source

One‐Step Synthesis of Si–Graphene Heterostructures via in‐Flight Gas‐Phase Mixing for High‐Capacity Silicon‐Rich Anodes

ENERGY &ENVIRONMENTAL MATERIALS, EarlyView.
A one‐step gas‐phase synthesis directly assembles amorphous Si nanoparticles with few‐layer graphene heterostructures via in‐flight mixing. Compositions with only 15 wt.% FLG deliver ~2800 mAh g−1 (Si + FLG) at 0.05 C and retain ~1400 mAh g−1 after 100 cycles at a high cycling rate of 1 C, enabled by a percolated, strain‐buffering graphene network that
Muhammad Ali, Mukarram Ali, Yasaman Jarrahizadeh, Axel Lorke, Michael A. Pope, Hartmut Wiggers   +5 more
wiley   +1 more source

Molten Salt Electrolyte for Enhanced Low‐Temperature Sodium Liquid Metal Batteries

ENERGY &ENVIRONMENTAL MATERIALS, EarlyView.
This study introduces the application of a low‐temperature, high‐conductivity, solvent‐free Na/KFSI molten salt electrolyte in sodium liquid metal batteries. Additionally, this electrolyte facilitates the formation of a stable and NaF‐rich cathode electrolyte interphase (CEI) on the alloy cathode, enabling stable cycling at an unprecedentedly low ...
Jingya Dong, Yewei Guo, Fuhao Zhang, Shuo Ye, Qiao Cu, Erbing Shi, Qingqing Dai, Kai Jiang, Qingfu Zhu, Haomiao Li, Kangli Wang   +10 more
wiley   +1 more source

Air Stability of Sulfide Solid Electrolytes: From Theoretical Insights to Practical Solutions

ENERGY &ENVIRONMENTAL MATERIALS, EarlyView.
This paper reviews research progress on the air stability of SSEs, covering their instability mechanisms and modification strategies, while outlining core challenges and future directions for practical applications. Sulfide solid electrolytes are pivotal for enabling high‐performance all‐solid‐state batteries due to their high ionic conductivity and ...
Hongbing Ding, Yue Hu, Xin Li, Yang Su, Xinlu Wang, Hongbo Zhang, Guixia Liu, Wensheng Yu, Xiangting Dong, Jinxian Wang, Xin Wang   +10 more
wiley   +1 more source

Sustainable Revival of Spent Lithium Iron Phosphate Cathodes in Li‐Ion Batteries: Recycling and Surface Engineering Approaches

ENERGY &ENVIRONMENTAL MATERIALS, EarlyView.
Schematic illustration of the lifecycle of LiFePO4 cathodes. Lithiation and delithiation reactions happen through its discharging and charging processes. Recycling pathways including hydrometallurgy, pyrometallurgy, and direct regeneration enable sustainable reuse of spent LFP materials. Surface modification approaches (carbon, polymer, and metal/metal
Yan He, Ruigang Wang
wiley   +1 more source