Results 71 to 80 of about 293 (107)

CBN cutting tool's surface roughness and tool wear prediction using JOA-optimized CNN-LSTM. [PDF]

Sci Rep
Khetre S, Bongale A, Kumar S.
europepmc   +1 more source

Optimization of machining parameters while turning AISI316 stainless steel using response surface methodology. [PDF]

Sci Rep
Surya MS.
europepmc   +1 more source

Computational and Experimental Analysis of Surface Residual Stresses in Polymers via Micro-Milling. [PDF]

Polymers (Basel)
Sun F, Fu G, Huo D.
europepmc   +1 more source

Optimizing the drilling performance of Syagrus romanzoffiana fiber biocomposites: minimizing delamination with RSM and ANN modeling. [PDF]

Sci Rep
Ferfari O, Belaadi A, Krishnasamy P, Ghernaout D, Mukalazi H.   +4 more
europepmc   +1 more source

Processing of Layered Composite Products Manufactured on the Basis of Bioresin Reinforced with Flax Fabric Using Milling Technology. [PDF]

Materials (Basel)
Frącz W, Ryzińska G, Skoczylas L, Bąk Ł, Janowski G.   +4 more
europepmc   +1 more source

An Insight into Chip and Surface Texture Shaping Under Finish Turning of Powder Steels Infiltrated with Tin Bronze. [PDF]

Materials (Basel)
Leksycki K, Feldshtein E, Dyachkova L, Arkusz K, Ceglewski M, Czerwiec Ł.   +5 more
europepmc   +1 more source

Drilling Machinability of Glass, Basalt, and Hybrid Epoxy Composites: Thrust Force, Thermal Load, and Hole Quality. [PDF]

Polymers (Basel)
Yarar E, Özsoy Mİ, Fidan S, Ürgün S, Bora MÖ.   +4 more
europepmc   +1 more source

Enhancing orthogonal finishing machining of Ti6Al4V with laser-ablated tool geometry modifications. [PDF]

Int J Adv Manuf Technol
Kneubühler F, Zhang N, Haudenschild L, Klippel H, Putzer M, Urundolil Kumaran V, Kuffa M, Wegener K.   +7 more
europepmc   +1 more source

Transient Temperature at Tool-Chip Interface during Initial Period of Chip Formation in Orthogonal Cutting of Inconel 718. [PDF]

Materials (Basel)
Alammari Y, Weng J, Saelzer J, Biermann D.   +3 more
europepmc   +1 more source