Results 41 to 50 of about 473,613 (309)
Advances in Mechanical Engineering, 2017 Aiming at addressing the load behavior of iron ore particles in a ball mill, a design of experimental method was used to define a series of discrete element method simulation conditions with two factors being the mill speed and lifter height.
Yuxing Peng +4 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Scientific ReportsRockfall, as a common geological hazard, exhibits extremely complex impact dynamic behaviors that are significantly influenced by factors like the impact falling height and the composition of soil layers.
Yulong Zhang +5 more
doaj +1 more source
Research on Image Detection of Thin-Vein Precious Metal Ores and Rocks Based on Improved YOLOv8n
Applied SciencesTo address the high-dilution issues arising from efficient mining methods such as medium-deep drilling for underground thin veins of precious metals, detecting raw rock fragments after blasting for subsequent sorting has become a cutting-edge research ...
Heyan Zhou +4 more
doaj +1 more source
IEEE Access, 2019 This paper is to investigate the mechanical characteristics of non-equidistant thrust system in an EPB shield machine with a diameter of 6.15 m applied in Beijing Metro Line 6 construction.
Kongshu Deng +3 more
doaj +1 more source
Application of Raman and Photoluminescence Spectroscopy to MgO‐C Refractories
Advanced Engineering Materials, EarlyView.Visible to near infrared luminescence of MgO is studied on MgO‐C bricks and nominally pure MgO powder, with focus on two similar sharp high‐intensity signals, at 699 and 871 nm, each surrounded by symmetrical sidebands. The nature of these sidebands is investigated by temperature‐dependent spectroscopic measurements, confirming phonon involvement by ...
Julia Richter +5 more
wiley +1 more source
SensorsAcquisition of joint attitudes is vital in mine geology but often constrained by underground conditions, while manual cataloging remains inefficient and subjective.
Guang Li +4 more
doaj +1 more source
Gong-kuang zidonghua, 2020 Taking transparent coal seam, transparent fully-mechanized mining equipment and transparent decision-making and control as core, concept of intelligent mining based on transparent longwall face was put forward, namely based on enhanced geological ...
WANG Feng
doaj +1 more source
Injuries, Illnesses, and Fatal Injuries in Mining in 2010 [PDF]
, 2013 [Excerpt] Workers in the mining industry continue to face a higher risk of fatal injury than average American workers. Although the rate of nonfatal injuries and illnesses in mining is less than the average reported for private industry, these injuries ...
Smith, Sean
core +1 more source
Advanced Functional Materials, EarlyView.The study presents biodegradable and recyclable mixed‐matrix membranes (MMMs), hydrogels, and cryogels using luminescent nanoscale metal‐organic frameworks (nMOFs) and biopolymers. These bio‐nMOF‐MMMs combine europium‐based nMOFs as probes for the status of the materials with the biopolymers agar and gelatine and present alternatives to conventional ...
Moritz Maxeiner +4 more
wiley +1 more source