Results 11 to 20 of about 26,745 (262)

UVC-PURGE: A Novel Cost-Effective Disinfection Robot for Combating COVID-19 Pandemic

open access: yesIEEE Access, 2022
During the COVID-19 pandemic, surface disinfection using prevailing chemical disinfection methods had several limitations. Due to cost-inefficiency and the inability to disinfect shaded places, static UVC lamps cannot address these limitations properly ...
Akib Zaman   +11 more
doaj   +1 more source

MIST ve BRICS ülkelerinde Uluslararası Ticaret, Küreselleşme ve Fosil Enerji Kullanımı Çevresel Bozulmayı Nasıl Etkiliyor?: Panel Veri Analizi Tahmini

open access: yesSelçuk Üniversitesi Sosyal Bilimler Meslek Yüksekokulu Dergisi, 2021
Karbon emisyonundaki artış, çevre kirliliğinin en önemli sebeplerden biridir. Karbon emisyon oranları, iklim değişikliği gibi çevresel faktörler üzerinde belirgin derecede etkiye sahiptir.
Aslı Özpolat   +2 more
doaj   +1 more source

Analysis of Meteorological Factors That Start Operação Comboio in the Anchieta-Imigrantes System in Brazil: Fog Case Study [PDF]

open access: yesRevista Brasileira de Meteorologia
Anchieta-Imigrantes System (AIS) is one of Brazil's primary highways, connecting São Paulo to the Port of Santos. In AIS, Operação Comboio (OC) is activated when visibility drops below 100 m.
Brenda Almeida Santos, Rita Yuri Ynoue
doaj   +1 more source

Expansion Waves at the Outlet of the Supersonic Two-Phase Flow Nozzle

open access: yesJournal of Thermal Science and Technology, 2007
Two-phase flow nozzles are used in the total flow system of geothermal power plants and in the ejector of the refrigeration cycle, etc. One of the most important functions of the two-phase flow nozzle is converting two-phase flow thermal energy into ...
Masafumi NAKAGAWA   +3 more
doaj   +1 more source

Analog Ensemble Forecasting System for Low-Visibility Conditions over the Main Airports of Morocco

open access: yesAtmosphere, 2022
Low-visibility conditions (LVC) are a common cause of air traffic, road, and sailing fatalities. Forecasting those conditions is an arduous challenge for weather forecasters all over the world.
Badreddine Alaoui   +3 more
doaj   +1 more source

Drying of a nanoparticle solution droplet and development of film fabrication method using ultra-sonic mist

open access: yesMechanical Engineering Journal, 2017
The purpose of present study is to investigate the nanoparticle dispersion formation under drying process of micro solution droplet including nanoparticles, and develop the film fabrication method on the basis of the formation result.
Shin OKUBO, Go MURASAWA
doaj   +1 more source

A case study on the shear behavior of pretensioned Spun Precast Concrete (SPC) piles

open access: yesCase Studies in Construction Materials, 2023
Pretensioned Spun Precast concrete (SPC) pile has become a very popular solution for deep foundation systems for its easier installation, higher bearing capacity, and overall cost-effectiveness.
Khondaker Sakil Ahmed   +3 more
doaj   +1 more source

A comparative study on the influence of MWCNT, GO, and Al(OH)3 gel matrix modification on hierarchical structured composite reinforced with needle-punched jute fiber and glass fiber

open access: yesResults in Engineering
The main objective of this paper was to identify the influence of different filler materials on the properties of hybrid composites. The hybrid composites were fabricated using randomly oriented glass fiber mats, needle-punched jute fiber mats, and epoxy
Mahima Haque   +4 more
doaj   +1 more source

Potential of carboxymethyl cellulose solution to increase the shale stability

open access: yesScientific Reports, 2023
Slope failures in Bangladesh's Chittagong division are a growing concern, with fatalities increasing from 19 in 2000 to 162 in 2017 and projected to rise further.
AKM Badrul Alam   +6 more
doaj   +1 more source

Unidirectional Tape‐Based Composites from Hemp and Pineapple Leaf Fiber: Mechanical Performance in Conventional and Bio‐Based Matrices

open access: yesAdvanced Engineering Materials, EarlyView.
The study investigates novel semi‐finished products made of unidirectionally arranged hemp or pineapple leaf fiber‐reinforced composites produced from different matrices. The materials are analyzed in terms of their mechanical and interfacial properties and void content.
Nina Graupner   +22 more
wiley   +1 more source

Home - About - Disclaimer - Privacy