Results 51 to 60 of about 93,860 (299)
Thermoreflectance Detection of Point Defects Resulting from Focused Ion Beam Milling
Advanced Engineering Materials, EarlyView.Focused ion beam (FIB) milling is a common tool for nanoscale material processing, however irradiation damage, redeposition, and contamination can occur. We use several characterization tools to show FIB‐induced effects beyond 1 mm from the milled area.
Thomas W. Pfeifer +3 more
wiley +1 more source
Results in Physics, 2018 In microsystem technologies, the microring resonators (MRRs) can be used as a filter device. A wavelength-selective modified add-drop MRR filter is used for adding and dropping a particular wavelength in order to control the light propagation within the ...
Iraj S. Amiri +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Passively mode-locked semiconductor laser for coherent population trapping in 87Rb [PDF]
, 2011 Passively mode-locked semiconductor laser for coherent population trapping in <sup>87</sup>Rb is reported. The laser material used is a 793nm GaAs/Al<sub>x</sub>Ga<sub>1-x</sub>As single quantum well (QW) graded index ...
Bryce, C.A. +6 more
core +1 more source
Ultrafast Raman laser mode-locked by nanotubes [PDF]
, 2011 We demonstrate passive mode-locking of a Raman fiber laser using a nanotube-based saturable absorber coupled to a net normal dispersion cavity. This generates highly chirped 500 ps pulses.
A. C. Ferrari +29 more
core +3 more sources
Handbook of Establishing and Maintaining Oxygen‐Free Atmospheres
Advanced Engineering Materials, EarlyView.This study presents a practical framework for creating oxygen‐free atmospheres at ambient pressure using silane‐doped inert gases. The results show that ultra‐low oxygen levels and strongly reduced water content can be achieved through controlled silane dosing, drying systems, and sensor monitoring.
Sascha Jan Zimmermann +3 more
wiley +1 more source
Sub-100 fs pulse generation from dispersion-managed mode-locked Er:ZBLAN fiber laser at 2.8 μm
High Power Laser Science and EngineeringWe demonstrate the sub-100 fs pulse generation from a dispersion-managed mode-locked Er:ZBLAN fiber laser at 2.8 μm. Both numerical simulation and experiment demonstrate that stretched-pulse and dissipative soliton mode lockings coexist in the near-zero ...
Xiabing Zhou, Zhipeng Qin, Guoqiang Xie
doaj +1 more source
IEEE Photonics Journal, 2015 A dual-wavelength rational harmonic mode-locked fiber ring laser with different repetition frequencies is theoretically analyzed and experimentally demonstrated.
Yuejiao Zi +6 more
doaj +1 more source
Fatigue Crack Initiation and Growth in Nanocrystalline Ni at Multiple Length‐Scales
Advanced Engineering Materials, EarlyView.Overview of miniaturized in situ SEM fatigue setup and resultant fatigue crack growth data for nanocrystalline Ni. The presented study focuses on the analysis of fatigue crack growth rate (FCGR) in focused ion beam‐notched microcantilevers prepared from nanocrystalline (NC) Ni as a model material.
Igor Moravcik +7 more
wiley +1 more source
IEEE Photonics Journal, 2017 We investigate integrated mode-locked laser diodes with distributed Bragg reflectors fabricated in the JePPIX-Oclaro indium phosphide photonics platform.
Torrey Thiessen, Joyce K. S. Poon
doaj +1 more source